0
How can you use a dual trace scope to make sure that the injectors are firing at the correct time?
Add your answer:
Earn +20 pts
Is this a correct sentence You can search everywhere I live. You can trace everywhere I am?
The two sentences are grammatically correct.
Can you trace a shell back to a gun?
Sometimes. The firing pin and extractor may leave marks on an ejected shell that can be matched to a gun.
Is this a correct sentence You can search everywhere I live You can trace everywhere I am?
No. While "everywhere" is a relative adverb here, replacing the more formal "in every place that", the sentence is not correct due to the lack of punctuation. It would be better written as You can search everywhere I live; you can trace everywhere I am.Even better would be to separate it as two sentences.
What bank has the sort code 40-12-05?
We are unble to trace this sort code. Please double check that you have the correct code.
What is the firing order for 1991 Suzuki Sidekick?
The eight-valve engine distributor rotor turns clockwise with a firing order of 1-3-4-2. The sixteen-valve engine has the same firing order but the rotor turns counterclockwise. The number one distributor terminal is not the same for both engines. Make sure to trace the number one spark plug wire back to the distributor for verification.
Wire to electric fuel pump has low voltage?
if you have checked the voltage with a dvom then you need to verify that the power source at the fuel pump relay is correct, if it has the correct voltage pre-relay then your problem is post-relay. if the voltage is not correct pre-relay then simply trace and repair the power source. if the problem is post relay then check the output voltage directly at the relay, if voltage is good trace and repair line from relay to pump. if voltage is not correct then replace the fuel pump relay
What is the firing order on the distributor cap for a 1990 Chevrolet 1500 5.0l?
The firing order on all small block chevys is 18436572. It should be imorinted on the intake. Trace the number one plug wire back to the dist. It's the one on the left (drivers) side of the engine at the front of the motor. The dist rotates clockwise.
Working principle of dual trace oscilloscope?
Dual-trace operation allows you to view two independent signal sources as a dual display on a single CRT. This operation allows an accurate means of making amplitude, phase, time displacement, or frequency comparisons and measurements between two signals. A dual-trace oscilloscope should not be confused with a dual-beam oscilloscope. Dual-beam oscilloscopes produce two separate electron beams on a single scope, which can be individually or jointly controlled. Dual-trace refers to a single beam in a CRT that is shared by two channels.
What nicknames does Shane Trace go by?
Shane Trace goes by Trace.
Which http methods are used to show the client what the server is receiving?
Trace
Why does the fuse keeping blowing for the remote entry system in a 1999 Avalon?
Blown fuses mean there is a short somewhere in the circuit. You need to trace it out to correct the problem.
How do you trace down a dead fuel injector on a 1991 Chevrolet caprice?
The 91 Caprice is throttle body injected and has 2 fuel injectors mounted above a Rochester throttle body. The easiest way to check for an injector that is not working correctly is to remove the air cleaner assembly, start the car and visually inspect the base of the injectors for a smooth consistent spray pattern. If the pattern is absent or intermittent on both injectors it may indicate a problem elsewhere, the ECM or a maybe a wiring issue or sensor. If it is a single injector that is acting up it could be the injector or a wiring problem to that injector which could be tested with a multimeter.
