Open the washer door and at the top of the inside seal there is a plastic nipple (this is where the water comes out of) ...Make sure that nipple hasn't worked itself loose (and pushed back from the seal.) If it is pull it back thru the hole and line it up with the impression in the seal. We had the same problem and this fixed it.
GE front loading washer does not come with a no leak guaruntee.
Usually a leaking hose into or out of the water pump (depending on its location), or the water pump gasket.
The washer pump is on the bottom of the washer reservoir.
Check the rear window washer resivoir.
Pump or fitting is leaking underneath the washer, the hose where it attaches to the washer needs tightening or the hose itself is not high enough to prevent the water from just running out.
Mold and water leaking can be a problem with front load washers. They may also not be as energy efficient as they claim. They tend to be more expensive than other washer and dryer pairs.
Check water pump and pump gasket ck freeze plugs on front, and therm housing.
If it's leaking under the front of the water pump, it's probably the water pump.
There are a few things that can cause a coolant leak but in your case it is probably the water pump. When a water pump starts to go bad it will leak coolant from the bottom.
is coolant leaking from engine?or is it leaking from water pump and running down engine and appears to leak from engine
if it is not making any noise,or leaking from bottom of pump. Releif hole is on bottom of pump,if leaking replace pump.
It is on the bottom of the washer bottle.