Want this question answered?
Be notified when an answer is posted
Perhaps the pilot light is out and the gas has been turned off at the valve.
The pilot light goes out when the fireplace is turned off because it is no longer needed to keep the flame ignited. The pilot light is a small flame that stays lit constantly to ignite the main burner when the fireplace is turned on. When the fireplace is turned off, there is no need for the pilot light to continue burning, so it goes out.
No because water heaters have a safety valves and when the pilot light goes out the safety valve shuts off the gas
If the pilot light goes out on your gas appliance, follow these steps: Turn off the gas supply to the appliance. Wait for the gas to dissipate before attempting to relight the pilot light. Follow the manufacturer's instructions for relighting the pilot light. If you are unsure or uncomfortable, contact a professional technician for assistance.
When pilot light goes out, gas flows out of the pilot light nozzle. If out has continued for a long time, a gas cloud can develop around the furnace. When you go to light the pilot light, you'll ignite this gas cloud and make a big fire ball. If your basement is drafty, you might never get a huge cloud of gas hovering around your furnace. When you notice that your pilot light is out, you should shut off the gas to the furnace and allow any stray gas to dissipate before you turn the gas back on and light the pilot light. alliedallcityinc.com
You may mean a 'thermocouple' - this is a small metal bulb that sends a signal to the gas regulator that the pilot light is on or off. This is a safety feature that will not allow the gas regulator to open if the pilot light is off.
It is supposed to quit burning.
You can but it just has to be done manually..
To relight the pilot light on your Whirlpool oven, locate the pilot light assembly near the burner. Turn the gas valve to the "off" position and wait for the gas to dissipate. Then, turn the gas valve to the "pilot" position and press the ignition button to light the pilot. Hold the button for a few seconds to ensure the pilot stays lit. Finally, turn the gas valve back to the "on" position and test the oven to ensure it is working properly.
If you smell gas when the pilot light is lit on a gas heater, it could indicate a potential gas leak. The gas might not be burning completely due to a blocked pilot light or faulty burner, leading to the release of unburned gas. It's important to turn off the gas supply immediately, ventilate the area, and have a professional inspect and repair the heater to prevent any safety hazards.
No, electric water heaters do not need a pilot light. The heating element is heated by an electric current (similar to the 'eye' on an electric stove or the heaters in a toaster). When the circuit is completed, electric current flows through the element, and it gets hot, and when the electricity is turned off, the element starts cooling. In a gas water heater, the pilot light is a flame, which is always burning. When it's time to heat up the water, the main gas valve is opened, and the pilot light ignites the gas, so that the main burner heats up.
Same as any hot water heater. Turn the gas valve to off.