Typically the no parking signs also have arrows on them. The signs point in the direction where no parking is allowed. You can park up the sign but not beyond it, in the direction that the arrow is pointing.
It means you may not park your car between the sign that says "No parking here to corner" and the corner.
93 Geo Prizm parking lamp replacementI just changed the front right parking lamp on my 93 Geo Prizm, assuming your 96 is similar, here is how to do it: Under the hood, at the top of the juncture of the front fender, parking light assembly, and headlight assembly, there is a flat headed Phillips screw (installed vertically); remove the screw, the parking light assembly should then be somewhat loose. (After this screw has been reomoved, the unit is then held in place by a small locator shaft/pin with a notched/bulb head that fits into a sleeve in the supporting structure. This pin is located in the lower front corner of the assembly and is aligned going straight back). The whole assembly can then be pulled forward and removed. It will take some force to remove and may take a little coaxing from the back. If you pry it, use a wood shim or similar to keep from damaging the unit or the fender. It will come out straight forward - do not pull at an angle.After removing the assembly, the bulb can be accesed from the back of the unit. Twist the socket to remove it from the back of the unit and replace the bulb.
Type your answer here... front
The sign reads, "Don't even think about parking here."
Parking meters are at the parking lot entrances. There are numerous levels of parking here. Express parking, prestige parking, prestige limousine pickup, and short and long park passes.
Don't Park Here!
Not enough detail here to determine fault
Here's how I did it. The manual says to just slide back the yellow light cover, from the front toward the rear of the car, and that it will then pop out. Well, that's BS. It won't slide back, as one would expect. I used a shoehorn or something similar such as a small plastic putty knife. (You can use a soft cloth or towel to protect the edge of the bumper). I wedged the shoehorn/putty knife between the front edge of the light cover and the cut-out in which the cover sits. Then I gently pried that front edge up and back until it popped out. To replace it, pop it back in. That part is pretty straighforward. Hope this helps.
Don't Even Think of Parking Here - 2011 was released on: USA: 2011 (Look Better: Critical Visions Symposium)
If you are parking in a Parallel park with two cars on either end of your car, make a reverse entry and park the car as it is easier and accurate, if you are parking parallelly with two cars on your either side, park your car in take-off position i.e. face outwards as it is easier to get out... on an elevated or lift parking also, park in takeoff position...front outwards, when parking on an incline, if the car's front is facing the slope, keep the car in reverse gear and if the front is opposite to the slope, keep the car in first gear; apply the parking brakes in all the cases...wherever you park, leave a reasonable amount of door-opening space so as to not obstruct yourself or others...
60 % Type your answer here...
Wanted to get the answer here, - heck, had to figure it out on my own... mine is Corolla 96, front parking light Replace a bulb - big deal, but you've gotta get it out first. Here is HOW: 1) Open the hood. There is a flat head screw next to your parking light, - easy to find. Remove it. DO NOT DROP IT INSIDE - that was my mistake... 2) That was the ONLY screw holding the light. Now pull the thing straight forward... ONLY STRAIGHT... harder... pry it with a screwdriver from back, - it won't break, not this time yet... Pop! - it's all yours. 3) The rest is trivial: turn the socket, replace the bulb. Assemble in backwards order, it's much easier.