answersLogoWhite

0


Best Answer

Yes it does, providing there is an air filter in place. You will also even out the temperatures in different parts of the home. This is where you can do a better job of cleaning the air and removing dust and particulate by choosing a higher efficiency filter. A "pleated" filter will increase the removal of particulate without adding increased restriction to the furnace/ ac system. Many people make the mistake however, of installing an electrostatic/ washable filter of the same physical size as the original filter they removed. The problem they create is that while the electrostatic filter is more efficient in that some will filter out mold spores and cigarette smoke, etc, they increase the temperature rise in the case of a furnace, or the temp. drop in the case of an a/c system. In the case of a furnace this will increase the risk of errant safety limit trips and furnace operation above the temperature rise specified by the manufacturer. In the case of a/c systems, the increased restriction may cause icing of the a/c coil. The furnace nameplate should be checked for the listed temperature rise. Measure the temperature of the air entering the unit and leaving the unit. After 10-15 minutes of operation the calculated "temperature rise" should fall within the range listed on the rating plate. If going to an electrostatic filter, have a good HVAC contractor install a filter rack diagonally in the return air. This allows you to install a larger surface area filter that will reduce the static pressure drop of the filter in the system. One option I have installed for many customers is called a "filter enhancer". It acts as the electrostatic filter does, by charging the air passing over the installed probe with electricity. The charged particles are then caught by the pleated filter. This type of setup costs lots less than electronic air filters and has far less in the way of maintenance issues. It works on the principle of electropheresis.(I may have not spelled it right) The enhancer I install is the airscreen 6000 manufatured by Cimatec. Good luck! lc

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Does setting the central ac fan to on to clean the air?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the forced air fan on a central unit?

in air handling unit


Is the air on if you turn the fan on on a central air conditioner?

No. If your referring to the fan on switch on the thermostat. The answer is no only the indoor fan runs if the thermostat is properly wired.


1998 kia sportage when you turn on the air or heater no air blows into the car why?

If the fan is running, you could have an accumulation of leaves under the cowl, or in the squrrell cage of the fan, been there, done that. Not hard to clean, remove the cowl and clean, remove the fan and clean.


Where is central air fan relay switch?

The switch is on your thermostat.


How do you clean a Duracraft window fan?

try an air compressor.


What is the best air condition setting for a 2007 Dodge caravan?

Full cold, medium fan, recirculation or max settingFull cold, medium fan, recirculation or max setting


Why would your central air conditioner fail to reach the thermostat set temp while running continuously?

Make sure your air filter is clean. A dirty air filter can block air flow. If both the fan and the compressor are coming on, there may be a low charge. If only the fan is coming on, the compressor could be burned up.


You have an electric forced air furnace and central air. why does the central air fan run when furnace comes on?

You must have a heat pump with electric auxilliary heat.


Heater problems on ford 1999 expedition?

the heater blows warm air when fan is on low but blows cold air when fan is turn to higher setting


Is it ok to run the fan on central air unit without cooling to circulate air?

Yes, no problem


Should you run the furnace fan along with the central air to help circulate cool air threw out house?

With central air the furnace fan must be running to provide the air to the living space. If the furnace fan is not running then you get no air out of the ducts and the A-coil (the part of the ac system that is in your furnace duct) will freeze and shut down the compressor (the part that is outside).


Can a thermostat cause heater in house to blow cold air?

No, not if it's on a heat setting. Most home thermostats have a "Fan" setting that will blow cold air if the attic is cold.