Hi
I have not had any experience with this machine, But I do have a new one sitting in my shed,straight from the assembly line,last one built I believers, has not yet been assembled,only needs acouple of linkages and three jocky pullies,
to complete has never been started , =unfinished project
Formula+ or Syn3
40 oz.
between $800 - $1200 depending on who you have do it.
about 1200$ but i can do it cheaper 4235047514
I used to have a datsun 1200 sss engine in my chevette. I'm pretty sure the standard chevette transmission was used.
It's just a vent hose. It doesn't connect to anything other than the transmission.
if you are in the U.K. £1200 + vat hope its worth it
usually 1200-1800 at a trans shop.Dealers are twice that.
For me it cost 1200 dollars out the door. (los Angeles area)
for 8 bit synchronous serial transmission total transmitted characters will be 1200/8 and for asynchronous transmission with 1 stop total bit will be (8+1+1=10) i.e. (8 bit + start bit+stop bit) so transmitted characters will be 1200/10
i don't know about older models but my sportster holds 3 quarts of oil and the tranny is all together its 07 custom 1200
To change the transmission fluid in a 2006 Harley Sportster 1200, first ensure the bike is on a level surface and warm the engine slightly. Remove the transmission fluid drain plug located at the bottom of the transmission and let the old fluid drain completely. Replace the drain plug and refill the transmission with fresh fluid through the fill plug on the side, using the recommended type of transmission fluid. Finally, check the fluid level to ensure it's at the correct height and secure the fill plug.