Yes. Anything with wheels on the road needs a license plate, even a boat trailer or a flat-bed trailer.
I called the county clerk of where I live and he said yes. It has to have a plate. But a boat trailer or a small utility trailer don't have to have one. That is if you dont take it out of the state.
Not as long as you are driving and pulling it only in the state of TN. If you go out of state you will want to get a license plate.
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
Yes It Is Against The Law To Not Have One On... Mise well not give them an excuse to pull you over!!!
Yes, in Wisconsin, a travel trailer requires a license plate if it is over 1,000 pounds. The trailer must be registered with the Wisconsin Department of Transportation, and you will need to display a valid license plate on the trailer while towing it. It's important to ensure that the trailer is properly registered to comply with state laws.
In North Carolina, you do not need weighted tags specifically to pull a camper. However, if the combined weight of your vehicle and camper exceeds a certain threshold, you may need to register your vehicle accordingly and comply with other regulations. It's important to check with the North Carolina Division of Motor Vehicles for specific requirements based on your vehicle's weight and type of camper.
I assume you mean the rear license plate. Pull off the rear door inner panel -this comes with a firm pull, it is retained with spring clips- and access the bulb holder this way. You need to depress the two legs either side of the holder before it will come out.
Yes
Look above the license plate and find the bulb assembly, grasp the flat part turn it clockwise and pull it out, the bulb just pulls straight out.
there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle
how to change the license plate bulb onLook at the rear plate , then get on the ground so you can look up to the underside of the bumper, where the plate is. There are two Phillips screws the hold your plate light, remove both, pull down gently on the light, then turn it co you can see the rear and with both Hans turn the socket and pull, there you will find the bulb. change it and do the reverse to install.