Nitro or petrol powered ones yes, but electric ones no. Basically if the fuel is a flammable liquid you have to have a glow plug
The glow plus starter provides the original heat source -this is done with heat not a spark- to start the engine. After your car is on idle you could remove the glow plug starter and your car would continue running (try it if you want, ads that little bit of speed from less weight).
Possibly, You have flooded your engine and you have to wait or you have a flat Glow Lighter. Or you'r actual Car batteries are dead!
A nitro car is just like a remote control car, with the exception that the nitro car has a small engine that runs on nitro fuel.
To start a car, you charge up the glow plug starter. Once fully charged, prime the engine (place finger over the exhaust pipe exit and pull the engine starter cord or use your roto starter) and turn on your radio gear. Then plug the glow plug starter on top of the engine and turn the engine over again and it should fire.
It could be one of several problems. 1. Bad glow plug 2. Bad fuel 3. glow starter 4. gummed up engine 5. clogged air filter 6. motor gears shattered 7. bad engine 8. Starter is not working right. (traxxas) 9. clogged fuel lines 10. pistons jammed All these reasons are the most popular reasons about why a RC car will not start. hope this helps you out!
Contact Dhinesh 9524377290 tamilnadu India
You just need to do a little research, but there are some sites that sell nitro car parts such as; www.hobbytron.com/NitroRCCars.html or also www.andysautosport.com/auto_parts/dodge_nitro.html.
To remove the starter in your 05 Pontiac Grand Am you will need a socket wrench. You will also need a car jack to lift the car so you can reach the starter.
Yes, a starter has to be grounded to work.
nitro as it will get a better boost
my car with 15cxp nitro engine with gear ratio 8.5/1 can run about 60km/hod