If I were you I would take it back in and have your oil pump checked. My truck has had that happen before and unfortunately I had to put in a new engine because my oil pump went out and it spun all the bearings and tore up my engine. Try to tow it if you can.
Check to see if their is gas in the tank!
figured it out! now i have heat.
What kind of car/truck? I am changing the motor in a 99 cavalier. I have the door panel off and now I am trying to remove the motor.
Perhaps the blower motor has burned out. When you say that the relays are working indicates you've followed the circuit out to them. Now go from there to the motor and make sure there is power that far. If there is power to the motor and you have a good ground and it still does not work: replace the motor.
Dc current can be changed to Ac current by using an undulator.Wrong!The devices that change DC to AC are:an electronic power invertera mechanical motor-generator set (only used in very high power stationary applications)an electromechanical vibrator (now obsolete)
Cross Polka is a kind of music. It is a tune. Till now there has been 4 recordings of this tune.
I don't have the complete ans but I did find the screws holding the motor to the regulator structure. It took a dremel with a cutoff wheel to remove pieces of the inner door metal to expose the two hidden ones. Now to determine if the window should be up or down before removing the motor. Good luck to anyone with the same problem.
Check the main ground to your starter. It sounds to me like your soleniod has power, but you starter motor doesnt.
i don't now
Does it cranks?...What was the last thing that was done to it and what its doing now?...When was the last tune-up or relay chk/change?....First see if starter is making contact...make sure you have good power from your Battery + chk your fuses on top of Battery plus inside fuse panel
The easiest way would be to convert the AC power to DC by using a rectifier diode and a filter capacitor. In that way you can now run your DC motor on DC.
Didn't you hear about the change to digital tv? Old analog tv's will not tune the new digital TV stations.