0
Add your answer:
Earn +20 pts
Car stalls at every stop but will start again it will not stay on unless i keep the gas pedal down.?
tps throttle position sensor
Why does a 1995 dodge 2500 diesel will not stay in overdrive unless you let of the fuel pedal when you step back on the fuel pedal it down shifts?
Throttle position sensor.
Will rear cylinder leak cause break pedal to stay down?
Yes.
Clutch pedal wont stay down to change gear on vauxhall vectra 1991.1.8?
You have to keep it down with your foot!
Why does your clutch pedal stay down on your 1987 Honda Accord?
Broken clutch fork, or other parts.
Why does your 2000 Taurus start but not stay running unless you keep your foot on the gas pedal?
First thing to check / replace is the fuel filter. Next suspect is going to be the fuel pump, and if it is generating sufficient fuel line pressure.
What would cause the clutch pedal on a 1990 BMW 525i to stay in the down position?
Bad hydraulic cylinders.
1994 Chevy s10 with a 4.3 Vortec will just slow down while driving Sometimes if you stay on the pedal it will regain power And sometimes you have to pull over But you can start it back up?
bad fuel injector spider
What if your Volvo S40 will not stay running unless you keep your foot on the gas pedal?
probably failed throttle bypass solenoid or possibly throttle position sensor
Have 2002 s10 pickup when you press on the emergency brake pedal it goes down but wont stay down just pops back up?
The friction assembly that holds the pedal down is broken. Replacement of the complete e-brake pedal assembly is required. Your local Chevy dealer can get you that part for aprox $70 or you can try getting a used part from a salvage yard.
How do you fix it when I press the brake pedal the brake lights flash but do not stay steady until the brake pedal is pushed down hard on a 1989 Grand Marquis?
Adjust or replace the stoplight switch at the upper end of the brake pedal under dash area
How do you Know if the brake booster is working properly?
Brake booster can leak - both small hard to detect leaks & big leaks (easy because if it leaked a lot) your brake pedal would be really hard to push - just like it is when the engine is off & you pushed on the brakes. If a small eak sometimes harder to tell if it's bad - as brake pedal may "slowly" go down when you push on it. If it is bad the pedal will get harder to push. start engine leave in park hold brake pedal down for 1 minute, if it starts to go down then there is a leak somewhere otherwise it shoukld stay where it was
