yes you can you just need to change over the intake manifold from a carburetor to the throttle body intake
The throttle position sensor ( TPS ) is NOT ADJUSTABLE
You cant
how do i replace a throttle cable on a 1988 ford ranger pickup
It is located on the side of the throttle body, opposite side where the throttle cable connects.
The throttle body base gasket would be located between the throttle body and the intake manifold.
It is located in the throttle body.
To install a throttle cable on a 1977 Datsun pickup, first, remove the old cable by detaching it from the throttle linkage and the pedal assembly. Next, route the new throttle cable through the firewall and attach it to the throttle linkage on the engine, ensuring it is properly aligned. Finally, connect the other end to the accelerator pedal, adjusting the cable tension as needed for smooth operation. Test the throttle to ensure it opens and closes properly before securing everything in place.
On the intake manifold, to the right (passenger side) of the Throttle Body.
Could be a bad throttle body assembly
Could be a bad throttle body
Adjust the throttle stop screw located on the side of the carb that has your throttle linkage connected to it.
On the passenger side of the throttle body under the air intake