For the service light, Switch ignition on, The display will flash for 2 seconds, press the button next to fuel gauge until "----" appeares in the display, Release the button and switch the ignition off, and that should reset the light for you,
Turn the ignition key partially change display to "Trip A" and turn ignition OFF. Press the trip reset button and then turn the ignition key partially. Do not start engine. Hold reset button down until light goes off.
"Check Engine" light comes on when you turn ignition switch on and should go off when engine cranks.
Yes, when you turn on the ignition the Check Engine light will come on for a few seconds to show you the light is working. It will go out if no problem is detected.
If the check engine light is flashing when the engine is running , that indicates that an ignition misfire has been detected
there are many components that will display the check engine light if they are faulty. Go to a local mechanic and have them scan the computer. They will display the component that is faulty.
ensure there is diesel in the car. Turn on ignition but don't start the engine yet. Watch dashboard and look for a small light (not ignition light) look for a heater plug light. When this goes off then turn ignition full turn and engine should start.
you have an engine/ignition problem. HAve a garage read the codes and diagnose the problem soon.
ignition off press and hold the button next to the seatbelt light switch on ignition keep the button down untill display is at 0 and spanner is off turn ignition off All O:K:
If your check engine light is blinking that means an ignition misfire has been detected
If the light is not coming on when you turn on the ignition, check the bulb, it may be blown.
Simply turn on the ignition but do not attempt to start the engine. If the light bulb is good you will see the Check Engine light illuminate and stay on. If you do not see the Check Engine light, the bulb is defective or has been removed.