R C Young and admiral roofing are the top two roofing companies in san diego area. All depending on where in San Diego your looking for but if you search roofing companys near where ever your zip code is it will pull up the places closest to your location
Yes. If it requires a tanker with an unrestricted CDL, so it does with a permit, as well.
You will have to check you local codes. Sometimes if an outside plumber or electrician is involved they will have to pull a permit.
Yes, state police in every state do allow you to pull a trailer less then 35 feet.
you can get 1 from online just type in workers permit and it should pull up
A handful of states permit 57' trailers. However, most states only permit trailers up to 53' in length.
As a general rule, no, Amish do not pull out all their teeth.
In Canada every electrical installation requires a permit. The minimum cost for a new installation permit is $40.00. Maintenance of existing equipment requires no permit. For larger installations the price of the permit is based on the cost of the electrical job. Ten years ago if the new installation was under 500 dollars it did not require a permit. As government agencies now become privatized, the new companies that are taking over for the government are looking for ways of getting more and more dollars out of the general public. How does the saying go "Squeeze the public until they squeal, then back off a half a turn".
Should obtain an oversize/ overweight permit from the Texas Department of Transportation permit office .
You will need to pull a general residential building permit from the building inspector at your local municipality. You will need to be prepared to submit to numerous inspections in order to comply with building code.
The only type of nail for shingles is a roofing nail. Other nails have too small of a head and will pull through. You can use staples in an air gun, but they tend to pull through also.
Place the first course to overhangs the drip edges by about 1/4 inch and roll it out about 8 feet. At one end, drive nails every 3 inches along with the rake, then pull it taut and drive nails along the eave edge. Nails should be about 1 inch away from the edges.