This works for 05 Reg 2.8HDI Switch Ignition on (Do not start engine) Set Odometer to read total miles using the odometer button after the initial diagnostics have finished. Press and hold the Odometer button (OB) until the display reads CFG1,2 or3. ( These settings set the service intervals. CFG1 sets the longest distance between services and CFG 3 the shortest) Repeatedly pressing the OB briefly will change the CFG until the desired value is showing. Press and hold the Odometer button (OB) until the display reads the total milage again Turn off the ignition. I think the the CFG values are as follows: CFG1 : 20,000Miles or 2 Years CFG2 : 12,000Miles or 2 Years CFG3 : 10,000Miles or 2 Years I use CFG1 for the 2.8HDI It would appear that the same proceedure works for the Fiat Ducato as well.
how do you reset the service indicator on a 07 vauxhall combo van
After the cause of the code is repaired, the light is reset with a scan tool.After the cause of the code is repaired, the light is reset with a scan tool.
Disconnect the battery for 5 minutes will reset the computer on most models. If this does not work then your vehicles computer has the ability to hard set a check engine code and requires a special tool to reset the code.
Resetting the service light on a Citroen Nemo van is easily done. This service light will be set by a mechanic after the issue has been resolved.
be more specific on vehicle type
Fuse for rear lights on boxer van
Radio code needs to be inserted and station presets will need to be reset. Also clock will need to be reset. Nothing else.
if its the new 1.3hdi stop start it needs to go to a citroen dealer, i had same problem after it was serviced at local garage, i ran it to citroen and they told me it needed a service, i explained its just had a service, and they reset it for free :-)
You can set or adjust the clock on a Peugeot Boxer van by pushing on the little buttons below the clock using a pen point.
You can reset the factory stereo on a 1992 Volkswagen Transporter TDI van by disconnecting the battery for several seconds. Once you plug the battery back in, the radio will ask for a code. The code is essential in order to gain access to radio functions again. The radio code can be found in the owners manual. If the manual is not available, you can obtain the radio code from a dealership.
medium wheel base
use trip computer switch located on wiper lever when service indicator comes up press in button on side of lever