0
double
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is another word for an impact basin?
A crater, but usually basins are much bigger than your average crater. So they are known by another name since often their characteristics are slightly different; the proportions of the impacting object are larger.
How much force does it take to cut someone's head off?
I would estimate about 240 Newtons
How much force 20n needs from not moving?
To counteract a force of 20 N, you need another force, also of 20 N, in the opposite direction.
Suppose you apply a 10-N force to a 10-N cm's piston in a hyraulic devise if the force is transmitted to another piston with an area of 100 cm's by how much will the force be multiplied?
10
How much force does it take to crack a ski helmet during a fall?
A lot, but that doesn't mean it'll take a lot to injure your head.
If your mass was doubled what will happen to the force of gravity between you and the earth?
Nothing, the force of gravity is always the same no matter how much you weigh. It will only change if you go to another planet.
What is the negative about a screwdriver?
A screwdriver can damage the slot(s) by deforming the screw-head by either too much force or by using the improper size of screwdriver .
What is the force that makes an object slow down?
Friction is the force that slows objects down. Especially when combined with another force, such as gravity. When you have low friction, such as on ice, you slow down much slower than when you have high friction, such as on a road.
How much force is needed to knock someone's eyeballs out of their head?
if one can sneez without closing eyes he will found his balls in front of him`[i mean eye balls]
The weight lifter used a force of 980N to raise the barbell over her head in 521 seconds approximately how much work did she do in raising the barbell?
5105.8 J
When was Not Much Force created?
Not Much Force was created on 1915-08-04.
What is meant by the input force and output force of a machine?
the input force is how much energy or force you put into the machine, the output force is how much energy the machine produces with the end product.
