0
Add your answer:
Earn +20 pts
What is the sensor above the 350 engine oil pan and starter on your 1990 Chevy c1500 truck?
oil pressure switch or knock sensor
Will a swap from a 305 to a 350 cause lower oil pressure?
No it will not. Unless the oil pressure is low on the 350 engine. If you had good oil pressure in the 305, and the 350 don't then there is something wrong with the 350. Bad oil pump, engine bearings worn out, Oil pump pick-up screen stoped up. Things like that cause low oil pressure.
Will a oil pump knock when bad in a small block 350?
no
93 Silverado Z71 350 with super loud knock that came out of nowhere and only 81k babied miles what's up?
What does the oil pressure look like? If you have good oil pressure at an idle then I'd doubt that you have a bearing problem.IF the pressure is up, check for loose shafts, pulleys, check the flex plate for a crack... Just follow the sound.
What is the ideal oil pressure for a sbc 350?
Oil pressure should be 40 to 50 psi
What is 1979 oil pressure in a 350 engine?
The 1979 Chevrolet 350 cubic inch engine oil pressure should be in the 40 to 45 PSI range. The more miles an engine has the lower the oil pressure will be.
Where do you install the oil pressure gauge on a Chevy 350 small block?
how to install the oil pressure gauge on a Chevy 350 small block
Where is the oil pressure switch on 91 silverado 350?
The oil pressure on 91 Silverado 350 is at the rear of the engine on the driver's side, This unit is usually found above the oil filter.Ê
Can you hook up a oil pressure gauge to the port just above the oil filter on a Chevy 350?
Yes, that is a good place for an oil pressure guage. Try to keep the tube away from exhaust heat.
What can cause a knock in the motor of a 1997 Chevrolet 350?
Carbon build up, Bad rod bearing,main bearings low oil pressure. sounds like you need an engine rebuild.
What is the normal oil pressure on a 1977 Chevy 350 truck engine?
I have a 1974 Chevy truck with the 350 V8 and the engine is in good shape. At idle the oil pressure is 35-40 PSI, at driving speed it goes up to about 50 PSI. Hope this helps.
What indicates worn bearings?
Low oil pressure, engine knock / noise.
