0
Add your answer:
Earn +20 pts
How much does a cast iron 350 block weigh without the crank cam or pistons?
you need a casting number some have thicker walls 2bolt vrs 4bolt mains ect.
Is 010 block 2 bolt main or four bolt?
can be both ,i have a 350 010 2bolt main
What is proper timing for 69 Chevy pickup truck 350 4bolt min?
4 degrees BTDC.
What are the mains torqued at on a 1995 350 5.7l Ive heard 110 is that right?
Research tells me the following: 7/16 Main Caps (2 Bolt): 70ft-lbs 7/16 Inners (4Bolt): 70ft-lbs 7/16 Outers (4Bolt): 65ft-lbs 3/8 Outer Main (4Bolt): 40ft-lbs
How much hp does a 1970 4bolt main 350 motor have?
if it has the double hump heads..more than likely 350hp. If not 250hp
What is the Difference between a 4 bolt and 2bolt Chevy 350?
On a 4 bolt block, the three center main caps are held on by 4 bolts instead of 2.
Is it a 4bolt main?
It could be.
What would you estimte the horsepower at with a 350 4bolt main bored 060with a corvette ls8 crank and cam with 1966 327 camelback heads with 64cc chambers edelbrock 600cfm carb?
Around 375
Can you tell a 4bolt main by casting numbers on back of block?
no you cant. but i will go a bit deeper. im guessing you have the 350 with code ending in 0010 (its the most common)...i have had three of the 0010 350 blocks.... one was a two bolt and the other two were 4 bolt mains.
2bolt Chevy 350 or 4 bolt Chevy 350?
If you can get your hands on a 4 bolt main 350 that would be the better of the two. If all you have is the 2 bolt main, you can have a machine shop drill the holes out for you. That might cost a pretty penny. I built a 2 bolt main 350 for my mud truck i went all out with it heads, bored .30 over, 750 double pumper holly carb. ect. I never had a problem with it!
Does a 1976 Chevy G20 have a 2 or 4bolt main?
Probably 4 bolt.
Need to know gm engine id number 3970010?
4bolt 350ci
