answersLogoWhite

0


Best Answer

A drop clutch is a device that allows a drummer to close the hi-hat with a single stroke of a drumstick so that, while the drummer is using both feet to play two bass drum pedals, the drummer can play his sticks on the closed hi-hat. Without a drop clutch device on the hi hat, when the drummer takes his foot off the hi hat in order to play the second bass drum pedal, the hi hat stays open. The "stuck open" top hi hat does not lend itself to being played repetitively with a stick. The drop clutch, when struck once with a drumstick, allows the top hi hat cymbal to fall down onto the bottom hi hat cymbal by using gravity. Therefore, although the drummer is no longer using his or her foot to keep the hi hat closed, the drummer can play sticks on the closed hi hat cymbals while using his hi hat foot on a second bass drum pedal. When the drummer is ready to open and close the hi hat by foot, stepping on the hi hat pedal re-engages the drop clutch so that the top and bottom hi hat cymbals are held open again.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What does a hi-hat drop clutch do?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do you have to drop the transmission when replacing the clutch on a 1993 ford ranger?

yes.


Do you have to drop the transmission on a 92 Toyota Celica to change the clutch?

Yes


Do you have to drop tranny to change clutch 1992 celica?

That's pretty much a given with changing any clutch or torque converter.


Clutch grinding noise?

Your clutch is worn out,your pressure plate is shot,or there is a broken spring inside your clutch,you have to drop your tranny to check this out,been there ,done that! good luck,,toro2.


Why did your clutch pedal drop after you replaced your clutch kit?

It is likely that you had to dismantle your hydraulic clutch to do the work so.Is there air in the hydraulics?Is the linkage and clutch release bearing assembled correct.Is there a hole in the hydraulicsIf it is a cable or mechanical linkage is it assembled correctly?


What is FT on drum tabs?

Floor tom. It is the drum that has legs on it and sits on the floor. (Not the bass drum)


How do you do a wheelie on a 80cc Honda crf?

you have to rev the engine about half way then drop the clutch.


Is it possible to replace clutch without removing motor?

Yes just drop the tranny


How do you change out the clutch on a 1988 Honda accord?

You have to drop the engine and the trans Good luck


How to test an automobile clutch?

Find an open stretch of road drive at a steady speed of about 45mph shift into reverse and drop the clutch if your car keeps running you have a bad clutch if it stalls it was a good clutch .......The above suggestion is not only stupid, but dangerous.


Does the fact that my rx 8 clutch smell like it's burning indicate problems or over enthusiastic take offs?

If you keep burning the clutch, you will need to replace the clutch soon. You can burn the clutch in one take off, if you do it badly enough. Do not "drop the clutch" at ultra high rpm.


Do you have to drop a gearbox on a 1.8i cavalier expression to do a clutch?

The transmission must be removed to install a new clutch.The transmission must be removed to install a new clutch.