check for low alternator charge voltage when heater fan is on if alternator has anything lower then 13.5 volts have alternator load tested.. idead charge voltage is 13.8 to 14.5 volts is alt checks good scan abs codes and see whats up auto computers are very sensitive to voltage loos or overcharging. email me with more if you need help g ps check battery connections if any corrosion puul off batt cables negitive first pull center screw out and check both sides of bolt cables for corrosion if found soak cable ends in baking soda/water mixture to get rid of acid then wire brush cables also check the negative battery cable has a second wire that grounds your chassis. if that wire is hot when engine runs with heater on it means you have a bad body ground turn engine off remve black wire to chassis or radiator support and sand the terminal and sand the metal it attaches to. engine grounds are becoming more of a problem due to the use of more plastic being used means less ground points and aluminum tend to oxidize ground connections faster then cast iron does
The computer has detected a problem with the ABS ( Anti-lock Brake System ).
May be stop light switch--usually located at the upper end of the brake pedal under dash
it means that you have a bulb out somewhere on your truck.... IE backup light, brake light, turn signal, running light.. etc etc..
you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.
possible faulty brake light switch...sticking....usually located on top of metal arm connecting to your brake pedal. $10 part. There's a rubber bumper that the brake pedal switch hits against to turn off. When the bumper gets old it falls off (you will notice the pieces on the floor when you get in). Without the bumper in place the switch post just goes through the hole that the bumper is supposed to be in and is never depressed and the brake lights don't shut off.
on my sons 95 prism i had to loosen the nut on the brake light switch and turn it in a couple turns then retighten the nut, works fine
The brake light in your dash will turn on if the brake fluid level is low in your brake master cylinder in your engine compartment
There might be a switch attached to the brake pedal. When depressing the brake, at a certain point in the travel of that pedal, it trips a switch, which turns on the brake lights. Have someone check to see if the high mount brake light is or is not coming on, too. Chances are it is that brake light switch.
At least in the USA, a red light does not turn yellow. It turns green. A green light turns yellow, and then the yellow light turns red. IN THAT ORDER.
You set a heater to a certain temperature and when it reaches that it turns off.
No , the rear brake lights do not turn on when you use your parking brake , just the brake light on your dash is supposed to come on
It turns the rear brake lights on as a safety feature. The brake pedal is pushed in, causing the fluid to move forward in the brake cylinder,activating a brake light switch. Even if the vehicle is off, the lights will still come on.
In many cases, the brake light and the turn signal use the same bulb.
Same as any hot water heater. Turn the gas valve to off.
If it is a single bulb, it is probably the bulb. Many tail light bulbs have two separate filaments, with the turn/brake being much brighter than the marker light. The tail light and turn/brake circuits are completely separate.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
The brake fluid level may be low in the reservoir. If the reservoir is low it's telling you the brake pads are worn down. As the brake linings wear down the fluid level drops and eventually turns on the brake light. Have a mechanic check your brakes soon. See "Related Questions" below in case the brake light in question is/are the ones in the taillights. Not uncommon for Windstar brake lights to turn themselves on.