I thought it's attached to the side of the distributor. I may be wrong but I think that's where it is. I have a '94 with the 3.8 because I've considered buying the high performance one bout it's about $55.00 so I don't know, I haven't decided yet because it's still a bit too cold for doing most outside work here in MA.If I'm wrong please correct me. Thanks Steve H.
The 1995 Ford Ranger ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
It is located on the left fender.
it is inside the steering collar
On the bottom side of the engine( front of the car) just below the exhause manifold. It is easiest to remove the mounting plate from the body of the engine, as balancing the coils on the module as you remove and insert screws if a real pain in the but. If anyone has any suggestions on waterproofing this area, I would greatly appreciate it, as I have gone through three of these modules in three years due to water getting into it and shorting the module out. This last time it was a coolant leak around a seal on the top of the water pump, spraying right into the module that caused it. Argh!
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
remove and install... ...everyone should have a manual for their vehicle, and the library should have a professional shop manual available for FREE to make copies of...read up and repair like a PRO! Dave :)
Defective ignition switch.
If you trying to figure out what parts you can use between the years it depends on what your are using from the other trucks, some parts can even be swapped between makes, like a Buick ignition module will probably work, you need more info to clarify what you are trying to find out
the ignition module is located in the distributor
were is ignition drive module located in the engine
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
The module is located underneath the coil packs.
the ignition control modual is located on the backside of the fuse box under the dashboard.
drl module location on a ford ranger 1995
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
The ignition module is a small electrical part approx 3/4" x 1" that is located in the distributor by removing the distributor cap and looking for this small part that has about 4 wires going to it.
on 1994-95 Mustang v-8's the module is located on the passenger side fenderwell in front of the shock tower.
The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
I'm not sure if your Ranger is the same , but on my 1995 Explorer with a similar dash the GEM is in the center stack of the dash , to the left of the radio On a 1997 Ford Ranget 4x4 the Gem module is located as stated above. Behind the radio and to the left.