The ODBII connector is located on the passenger side of the center console, just beyond the console cover. You do not need to remove anything to plug in your diagnostic tool.
For a visual idea area of where it is, see image;
http://www.fixexpert.com/wiki/odb2.php?page=odb2&id=19758
A real picture of the connector (1 picture is worth a 1000 words)
http://fixexpert.com/obd2/data/Honda/crv/1999.jpg If you wish to look up others OBDII port locations for other vehicles try the main link at: http://www.fixexpert.com/wiki/OBD-2+Location Good Luck.
Wiki User
∙ 2007-11-08 01:10:18Yes.
Remove the positive cable from your 2004 Honda CRV starter. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
A picture of a Honda CRV rear window washer nozzle can be obtained from most Honda dealerships. The picture can also be found at most auto-parts stores.
In once saw one on a CRV that went around the tire - rather than through the middle, but didn't see what brand it was - sorry.
(belt) if it needs replacing do water pump at the same time it runs off the timing belt save time and money
driver left of the oil filter on a 2000 crv
Under the dash on the right side of the center console, passenger side of the vehicle.
Yes , the 2000 Honda CRV has an interference engine ( according to Gates - they manufacture timing belts etc. )
Possibly the lifters?!?
I use Mobil 1 Synthetic Gear Lubricant LS 75W-90 in my 2003 Honda Crv.
10W-30 is recommended.
DOT-3
The 2000 Honda CR-V does not have a VTEC engine.
would a 2004, 2005, Honda crv rear end differential fit Honda 2007 crv.
https://techinfo.honda.com/rjanisis/RJAAI001_OMANUAL.ASP?YEAR=2000
Synthetic 5W30 preferred.
There is not one.