Bank 1 is the bank next to the radiator. Sensor 1 is screwed into the exhaust manifold.
Assuming you mean P0135, that would be O2 sensor heater circuit malfunction (bank 1 sensor 1). If the wiring to bank 1 sensor 1 is not damaged, it is probably a bad bank 1 sensor 1 O2 sensor. Replace it.
There are three 02 sensors. The front left sensor is the forward most sensor, on the left bank of the engine. The next is the front right sensor on the right bank, the rear sensor is after the catalytic convertor. see below web site: http://www.courtesyparts.com/A32_O2-sensors.html
P0137 = O2 sensor circuit low volts (bank 1 sensor 2). Could be a faulty B1 S2 O2 sensor.
Not knowing what engine you have in that 02 Dodge, the bank of cylinders on a V6 or V8 that contains the #1 cylinder is bank 1. Sensor 1 would be the first sensor threaded into the exhaust system after that bank.
The P0155 refers to the Oxygen sensor on Bank 2, sensor 1. Bank 2 on your vehicle is on the passenger side of the engine. Sensor 1 is the first oxygen sensor in the exhaust pipe coming from the engine.
it's in the exhaust manifold
Bank 2 sensor 2 is the second sensor down from the exhaust manifold on the radiator side of the engine.
On a 2005 Honda Odyssey, the air fuel sensor bank 1 sensor 1 is located on the exhaust manifold, upstream of the catalytic converter. It is typically positioned near the front of the engine, close to the engine's cylinder head. This sensor monitors the air-fuel mixture for the engine's first bank of cylinders, helping to optimize fuel efficiency and emissions.
Driver's side, after the catalytic converter.
On a Honda Odyssey, Bank 1 Sensor 1 refers to the upstream oxygen sensor located on the engine's exhaust system. Specifically, it is typically situated before the catalytic converter on the driver's side of the engine. This sensor monitors the oxygen levels in the exhaust gases to help optimize engine performance and emissions. Accessing it may require lifting the vehicle for better visibility and reach.
On a Honda Odyssey, the bank 1 sensor 1, which is the upstream oxygen sensor, is located on the exhaust manifold or just before the catalytic converter on the engine side. This sensor monitors the oxygen levels in the exhaust gases to help manage the air-fuel mixture for optimal engine performance. Accessing it may require raising the vehicle and working from underneath, depending on the specific model year.
The bank 1 sensor 1 oxygen sensor on a 2002 Honda Accord is located on the header. It is right next to the sensor circuit.
3, sensor 1 bank 1, sensor 2 bank 1, sensor 2 bank 2
It is located right by the catalytic converter and should be fairly easy to swap out. It is located right by the catalytic converter and should be fairly easy to swap out.
where is bank 2 sensor 1 in a 2001 ford taurus ses 6 cyl
Bank one sensor one is above the converter.
A 2001 Caravan with the 3.3L does not have a bank 2. Bank 1 sensor 1 is the one screwed into the rear exhaust manifold. Bank 1 sensor 2 is the one screwed into the side of the catalytic converter.A 2001 Caravan with the 3.3L does not have a bank 2. Bank 1 sensor 1 is the one screwed into the rear exhaust manifold. Bank 1 sensor 2 is the one screwed into the side of the catalytic converter.