0
What else can I help you with?
Why will the heater only blow warm hot when driving at about 40 mph or greater on a 2004 Nissan Altima?
Coolant low in the radiator, or the vent down sills are plugged with leaves, and other debris.
Is the inlet port to the heater core on the top of the heater core?
Generally the coolant goes in the bottom of the heater core and out the top only because the coolant makes less noise this way if there happens to be trapped air in the system, otherwise it doesn't matter.
Why is your car defrosting on the inside and coolant leaking on the passenger side?
the heater core, heater core hoses or heater control valve is leaking
How do you replace the thermosat on a Dodge Dakota?
Drain about 1 gallon of coolant from radiator Remove housing at engine end of upper radiator hose Note how thermostat is installed Clean surfaces Replace thermostat and gasket Re-Install Refill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
Your 2001 pt cruiser heater is not putting out heat what can fix it?
Did you ever have a coolant leak?
How do you replace heater core in a Nissan quest?
To replace the heater core in a Nissan Quest, first, disconnect the battery and drain the coolant. Remove the dashboard and access the heater core housing, typically located near the firewall. Disconnect the hoses and electrical connectors, then remove the old heater core and install the new one, ensuring all connections are secure. Reassemble the dashboard, refill the coolant, and check for leaks.
How do you replace a heater core in a 1984-1989 Nissan 300zx?
To replace the heater core in a 1984-1989 Nissan 300ZX, first disconnect the battery and drain the coolant. Remove the dashboard and the center console to access the heater core. Detach the heater hoses from the core, unbolt it from the housing, and then install the new heater core by reversing the disassembly steps. Reconnect all components, refill the coolant, and check for leaks.
How do you replace a heater core on a 1987 Nissan Stanza?
To replace the heater core on a 1987 Nissan Stanza, first, disconnect the battery and drain the coolant from the radiator. Remove the dashboard and the center console to access the heater core housing. Disconnect the heater core hoses from the engine compartment, remove the mounting screws, and take out the old heater core. Install the new heater core in reverse order, making sure to reconnect all hoses and components before refilling the coolant and reassembling the dashboard.
How do you install block heater 2005 Chevrolet optra?
drain coolant from radiator, remove one of the frost plugs in engine block, install block heater in place of frost plug, refill radiator with coolant.
Where does the carb coolant hose go on a 1987 Nissan Pathfinder?
You have to tap into the heater hoses.
Where is the heater control valve on a mustang?
The heater control valve in a Mustang is located within the engine. It is right in the heater's core and where the coolant is located.
How do you install a block heater in a 1995 Nissan Pathfiner?
take it to a garage you fool
Where is the heater core located on a 91 Nissan maxima?
the heater core is behind the dash board
Why the heater on a 1992 Nissan maxim doesn't work?
The engine coolant level is low or needs to be flushed, and replaced.
How do you replace the heater core in a 2002 Buick LeSabre?
To replace the heater core in a 2002 Buick LeSabre, first disconnect the battery and drain the coolant from the radiator. Next, remove the dashboard and the heater assembly to access the heater core, which is located inside the vehicle. Disconnect the hoses and any mounting screws, then carefully remove the old heater core and install the new one. Reassemble the dashboard and heater assembly, refill the coolant, and reconnect the battery.
Where is the heater core located on a 2002 Chrysler town and country?
Look for two coolant lines going into the firewall. That's where your heater core is located.
How do you change a heater core on a Chevy g-30 series van?
To change the heater core on a Chevy G-30 series van, first, disconnect the battery and drain the coolant. Remove the dashboard and the heater assembly to access the heater core, which is typically located behind the firewall. Disconnect the heater core hoses, remove the mounting screws, and take out the old heater core. Install the new core, reassemble the heater assembly and dashboard, and refill the coolant before reconnecting the battery.
