0
Add your answer:
Earn +20 pts
Can you reuse the head bolts on a corsa 1.6?
I would not recommend it. The bolts are stretched during the torque procedure.
What happens if you reuse the old head bolts when replacing a head gasket?
The head bolts will not have the same clamping capabilities, since they were stretched on the first installation. You may blow a head gasket due to the bolts losing torque.
What is the head bolt torque for Lexus ls400?
The Lexus cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
What is the head torque setting for 74 hilux 12r engine?
The cylinder head bolt torque specification is 160 pounds. The cylinder head bolts should be torqued in 40 pound intervals.
How do you replace the whole head gasket set on 1994 sidekick 4wd?
Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
What do you torque the head on a 2002 Chevy cavalier 2.2 l ohv?
you torque the bolts until they are good and tight
Can head bolts be reused 2.2 cavalier?
you are suppose to replace head bolts they stretch and head will not torque right. When you buy the new gasket, order new bolts.
What are the head bolt torque specs for a 2002 Mitsubishi lancer?
10 bolts
How do you torque head bolts on Mazda 2002 protege lx?
check on youtube
What are the head bolt torque specs for a 1996 Chevy cavalier 2.2?
The 1996 Chevrolet Cavalier 2.2 liter engine had bolt torque specifications are 120 pounds. The head bolts should be torqued at 40 pound intervals.
What is the timing marks and torque value on the head bolts of a 2004 Chevy cavalier 2.2 motor?
i need the head bolt torque on a 04 chevi cavallier engine 2.2 DOHC
What are the head bolt torque specs for a 2002 kia sportage?
The 2002 Kia had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
What are the torque specifications for head bolts on a 1993 Chevy Cavalier?
the longer (new bolts) are to torqued to 48lbs and the shorter ones are to be torqued to 45lbs then turn the bolts an additional 90 degrees the bolts need to be replaced with new one because they are streched when you torque them down
What is the torque specs on a 2002 Kia Sedona cylinder head?
The torque specifications, for your 2002 Kia cylinder head, is 120 pounds per square inch. The head bolts should be torqued in 40 pound intervals.
What are the torque specs for a 1996 Chevy cavalier 2.2l engine all specs mains rods head bolts timing gear and chain line up points thanks?
What are the torque specs for a 1996 Chevy cavalier 2.2l
What are the torque spec for the head for 2001 Chevy cavalier 2.2?
The 2001 Chevy Cavalier 2.2 liter engine cylinder head bolt?ætorque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.
Cylinder head bolts torque Suzuki maruti 800cc?
maruti 800 2002 tightening torques of cylinder head
