Once you have removed the switch from the wiring that goes into the door, orient the wiring harness horizontally so that the black wiring (ground) is in the upper left. Starting at the lower left, count to the right from 1-7. Start again at the top with 8 being the black wire through to 14. Front Drivers window ( left front ) . To open, jump 8 & 9, and 11 & 14. To close, jump 8 & 14, and 11 & 9. Front Passengers window ( right front ) . To open, jump 8 & 13, and 11 & 12. To close, jump 8 & 12, and 11 & 13. Rear Drivers window ( left rear ) . To open, jump 8 & 3, and 11 & 1. To close, jump 8 & 1, and 11 & 3. Rear passenger window ( right rear ) . To open, jump 8 & 7, and 11 & 6. To close, jump 8 & 6, and 11 & 7. Door Locks To unlock, jump 8 & 2. To lock, jump 8 & 10 8 = Ground (negative - black) 11 = Positive (orange with black stripe) You can test around the window switch by using jumper wires from the ground (8) to one of the window connectors and jumping the positive (11) to the other window connector. Keep separate jumper wires in 8 and 11 throughout your testing. I find that a small paper clip acts as a nice jumper.
The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
The tire size is located on the drivers door jamb.
You need an O2 sensor socket or wrench from your auto parts store. Find out if the code is 1 or 2 left or right bank. The 1 is toward the front of viechle 2 towards the rear, bank 1 is drivers side. 2 is pass. side. Located under the viechle on the exaust system. When relplaced you can clear the code by removing the Negative battery cable for 10 min.
In the car owners manual is the location of fuses and relays and what circuits they are associated with.
According to the 2001 Mercury Cougar Owner Guide : The fuel pump shut off switch ( inertia switch ) is in the drivers foot well , behind the kick panel ( there is an access hole )
On a Mercury Villager ( being a front wheel drive vehicle ) The transaxle ( transmission ) is located in the engine compartment to the drivers side of the engine
behind the drivers side kick panel
It is in the drivers side kick panel.
On a 1997 Mercury Villager open the drivers door and on the latch pillar you will see an information sticker that shows the original size tires on the vehicle from the factory
At the top of the drivers side kick panel.
The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
If you mean the reset button on top of the FUEL PUMP SHUT OFF SWITCH the switch is located in the drivers footwell , behind the kick panel , by your left foot ( there is an access hole ) on a 2000 Mercury Villager
The fuel filter is located under the hood on the drivers side beneath the master cylinder
hidden back drivers side storage compartment, passengerside should have your Jack etc.
if it is equipped from factory it is mounted by the rear controls for the radio behind drivers seat
If it is electric it's switch is on the drivers door next to the switches for the front windows
It's the interior trim panel , just in front of the drivers door