answersLogoWhite

0


Best Answer

it is a knock sensor that is used to adjust the ignition timing.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the sensor on a 305 Chevy motor right next to the starter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Location of the starter motor on a 1998 mk6 ford escort zetec - front or rear?

The 1998 Ford Escort starter motor is located on the rear of the engine. The starter motor will be on the right hand side, near the bottom of the motor.


Where is the starter on a 1998 Chevy Lumina?

You don't. Starter fluid is a really good way to damage the motor inside because it created far more pressure than the motor is designed for. It's best to find and fix the problem rather than use the fluid. You would put starter fluid in the gas tank.


Where is the starter motor located on a Nissan nx coupe?

On the Nissan NX Coupe the starter is located to the right of the transaxle and to the left of the air cleaner. The air filter will need to be removed as well as the battery to access the starter motor.


Where is a Vauxhall combo starter motor?

I just removed a 1.7 Diesel starter motor. ALLWAYS DISCONNECT BATTERY NEGATIVE TERMINAL (10 mm) Remove top half of inlet manifold (8mm 12sided socket or spanner) Undo the two plastic bolts on the expansion tank (water bottle. 10mm) Move tank out the way Look down onto starter motor; remove bolt on which goes through bell housing into starter motor (16mm ) Jack car up; from underneath look up to starter motor, remove bolt which goes through the starter into gearbox (15mm) Remove nut from starter solenoid (little part of starter motor. 13 mm) Undo Philips bolt and disconnect wire You have removed your starter motor


Where is the location of starter for 1999 Chrysler 300m?

The starter is located under the motor on the drivers side...if you're looking at it from under the car (which is where you'll need to be) it will be to the right and back of the catalytic converter. There are two silver pipes that run right by it...

Related questions

Where is the knock sensor located on a 2006 Chevy Cobalt ls?

Right above the starter .


Where is the crankshaft position sensor on a 2001 Chevy Tahoe with a 5.3?

The crankshaft position sensor is located right above the starter, you may have to remove the starter for better visibility.


Crankshaft sensor location on Chevy Avalanche?

It's easy its just above the starter remove the starter with 1/2" socket your crank sensor is right there one 10mm socket


Is starter on left or right side of motor on 2001 Chevy silverado 1500?

setting in the seat, It will be on the right side of the engine.


Where is the crankshaft position sensor on a 2003 Chevy Tahoe with 5.3L?

It is right behind the starter and bolted into the side of the engine block. You will have to remove the starter to service it.


Where is the crank sensor for 1999 Chevy silverado 5.3l located?

It is mounted in the passenger side of the engine block right behind the starter. You will have to remove the starter to get to it.


Where is the starter motor located on a 1998 Chevy Malibu?

right in thr front underneath the car on the right side of the oil filiter


Where is the crankshaft position sensor on a 2008 Chevy Silverado V8 5.3?

It is bolted in the side of the engine block right BEHIND the starter. You will have to remove the starter to see are to even get to it.


Where is crank sensor on 03 Chevy 2500 hd truck?

It is bolted in the passenger side of the engine block RIGHT BEHIND the starter. You can not see or get to it untill you remove the starter.


Where is the starter located on a 2001 Chevy S-10?

at the bottom rear underside of the motor, right beside the oil pan.


Where is the fan motor temperature sensor on a 1995 Chevy lumina 3.8 liter?

on the right of your PC valve Where is the PC valve?


How do you replace a starter for a 2000 Chevy Blazer?

You need to disconnect your battery cables. On the right side under your motor is your starter you will have a - and a + wire disconnect them then take off two bolts and your starter will come right off. Then assemble the way you took it off.