.017
The thermostat for a 6 cylinder Ford pickup is in the top radiator hose inlet. The hose and inlet need to be removed to install the thermostat..
a 96 Mazda pickup
At this point I would do a compression check. If you find a cylinder 15% or more lower than the rest you probaby have a valve problem in that cylinder.
The slave cylinder is not on the firewall, it is at the transmission. The master cylinder is on the firewall.
Many Ford V-8's number 1 cylinder would be located on the passenger side bank most forward cylinder. It would be helpful to know which engine you have to be sure.
go with 27 on the dwell and 4 btdc on timing
8 cylinder 360
The thermostat for a 6 cylinder Ford pickup is in the top radiator hose inlet. The hose and inlet need to be removed to install the thermostat..
underneath the master cylinder
According to the Ford shop manual, the breaker point gap, for the 3 cylinder , should be set at 0.024-0.26.
will the 5 speed transmition out of a will a 1990 model ford pickup with a 6 cylinder , fit a 1990 modle 302?
It's a small silvery cylinder behind / under the dasboard.
FL1A Motorcraft 51515 Wix PH8A Fram
The point gap for the 200 cubic inch inline 6 cylinder engine in a 1966 Ford Mustang is ( .024 to .026 inch )
One fuel filter and a strainer on the fuel pump pickup.
We need to know what engine you have to answer this question.
most car manufacurers make small pickup trucks, like ford, toyota, chevy, gmc, ect