0
What causes a Toyota Camry 1988 steering to start vibrating after driving 3-4 miles when you release the gas pedal it stops vibrating but resumes vibration every time gas pedal is pressed?
Wiki User
∙ 19y ago
Inspect the front tires they may have a bubble on one of them it is possible that a wheel bearing is going out but the easy check is to inspect the tires after you have driven it a few miles
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
How do you keep the power steering pump pulley from turning when you try to loosen the bolt holding it to the pump on a 97 Suburban?
I a 97 pick up and the power steering pully is pressed on and pressed off
Is the main crankshaft pulley one solid piece?
In most cases no, it is two pieces pressed together with rubbber in between. It is called the vibration damper or the harmonic balancer.
How do you replace the front wheel bearing on a 2003 Pontiac vibe GT?
Take off the steering knuckle and press out the bearing and hub.Have the new bearing pressed in with the hub and re install the knuckle.
How do you unlock 1997 Mercedes Benz C230 ignition switch will not turn.?
Try jiggling the steering wheel while turning the key. Sometimes if the wheels are slights turned when you shut it off the steering wheel is pressed against the ignition switch inside the column. If that doesn't do it you probably will need a new key.
What will make a car make a grinding or roaring noise while driving when the accelerator is pressed and when let off it but not while cruising?
it may be the drive shaft u-joints if its rear wheel drive
What is compressional vibration?
Compressional vibration is a term used to describe a vibration that occurs as the result of compression. Compression can be described as when particles are pressed or forced together. Vibration occurs as a result of this pressure.
How do you keep the power steering pump pulley from turning when you try to loosen the bolt holding it to the pump on a 97 Suburban?
I a 97 pick up and the power steering pully is pressed on and pressed off
How do you replace the ball joints on a 02 Dodge Ram 1500 4x4 can they be pressed out of the steering knuckle or control arm or do you have to replace the entire steering knuckle or upper control arm?
They are pressed in and out with a set of special tools.
How do you remove the power steering pulley on a 355 Chevy?
That requires the use of a power steering pulley PULLER. ( A special tool ) The pulley is pressed on.
Is the power steering pump pulley pressed on or bolted on?
Normally, it is pressed on and tightened with an Allen screw. You undo the Allen screw before you try to pull it off.
How do you remove wheel bearing escourt 98 si?
Take the steering hub and knuckle to a machine shop. The bearing must be pressed out and a new one pressed into the hub.
What happens when a break rotor is warped?
The steering will pull rapidly from side to side if brakes are pressed hard. Itr will damage steering and possibly other parts.
What is the function of torsion spring in the friction plate?
when the friction plate is pressed by the pressure plate a torsional vibration is developed in order to dampen this vibration torsional springs are provided in the spring plate this springs are also called damper spring.
How do you remove the pulley off the power steering unit off a 1993 caviler?
its pressed on and needs a puller
Does power steering pulley have an allan screw on 95 suburban?
No... It is pressed on and it requires a special puller to get it off.
How do you remove power steering pump pulley on 1999 lesabre?
Pulley is pressed onto pump, you need a puller to remove.
How does a trumpet make it's noise?
When you play a trumpet, you buzz your lips. It creates a vibration that goes through the trumpet, and through the valves that you have pressed down (if you have pressed down any) and it comes out of the bell.
