The ignition control module is located within the distributor housing, so you need to remove the distributor, which is held in by two bolts, remember to slack off the valve cover bolts around the distributor, this facilitates the removal process, don't worry about the valve cover gasket it's an o-ring type gasket so it will reseal itself when you tighten the valve cover bolts .
A Mercedes-Benz 300SE ignition control module can be obtained from most Mercedes-Benz dealerships. The ignition control module, can be purchased at most auto-parts stores.
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Transitors
Have you checked for fuel and spark? Fuel pumps ad burnt ignition rotors are very commen on these vehicles
The only way I can explain it is to follow the wiring from your coil pack (where the spark plugs are) and the wires plug into the ignition module. Also go go www.wrenchead.ca and it has a manual that explains all. if you don't know the answer to a question please keep your moth shut ,please don't waste my time
Where is the ignition control module on a 1987 nissan 300zx
under the coil
First of all there is no Toyota Altima. An Altima is a Nissan. The ECM is a electronic control module which handle all the cars electronic information. Also referred to as your cars computer.
i WANT TO KNOW WHERE THE DAUL AIR BAGS ON ALTIMA 98?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
It should be on your drivers side fender, right next to your coil.
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
Where is the ignition control module located in my 1992 Crown Victoria
The ignition control module sit directly below the distributor.
ignition control module is under the distributor cap
Where is ignition control module on a 2001 mercury sable
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.