Bolt The Coil Bracket And Coil To The Block, The - Goes To The Distributor The + Hooks To The Ignition.
depends on if its standard or elec.
The large red wire is the battery or hot wire.
This wire should be pink/black.
To wire an ignition barrel in the Citroen Saxo, begin by disconnecting the wire at the negative terminal of the battery. A lead wire has to go to the ACC terminal on the ignition barrel. The starter relay wire goes to the ST terminal and the ignition wire is connected to the IGN terminal.
The Chevrolet 327 plug wire diagram can be obtained from most Chevrolet dealerships. The diagram can also be found in Chevrolet service manuals.
what about the ignition switch wiring
how to crank chev 350 out side the car on youtube
Yes they do.
PURPLE
1.8.4.3.6.5.7.2
8-10 degrees
I've never seen a 75 Chevy 350 that didn't come with HEI, as it was a mid-year introduction in 1974. However, if such a thing as a 75 Chevy with point distributor exists, there would be a steel wire running from the ignition switch to the hot side of the coil. The steel wire would need to be replaced with a copper wire. The steel wire acts as a resistor to reduce the voltage to the coil, which is not necessary on an HEI, and would limit the total voltage the coil could produce.
how do you adjust the timing on a 1977 350 Chevy engine k-10
8* BTDC
can a chevy truck with a 350 engine with a tbi cause detonation and pre- ignition?
The coils are bolted to the ignition control module, there is no coil wire as such.
The green wire is the negative and the yellow is the positive. It should be marked pos and neg on the module.
I would replace the ignition module in the distributor. Also need to make sure the coil and wire is good too.