answersLogoWhite

0

the fuel reset switch is directly behind the glove box, to reset it you just push the button on the top of the switch.

User Avatar

Wiki User

16y ago

Still curious? Ask our experts.

Chat with our AI personalities

DevinDevin
I've poured enough drinks to know that people don't always want advice—they just want to talk.
Chat with Devin
LaoLao
The path is yours to walk; I am only here to hold up a mirror.
Chat with Lao
JordanJordan
Looking for a career mentor? I've seen my fair share of shake-ups.
Chat with Jordan
More answers

There is a cut-off switch on the driver's side in the trunk. It is usually lableled.

User Avatar

Wiki User

19y ago
User Avatar

Go in trunk and look behind the carpet covering the left rear fender. There will be an inertia switch with a button on it.

User Avatar

Wiki User

15y ago
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset the fuel pump on a 1988 Mercury Grand Marquis?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Location of fuse box on 1987 Mercury Grand Marquis and where can you get a diagram of the fuse location in the fuse block?

ive found the fuse box in my 1988 marquis behind the plastic under the steering wheel, at the bottom there is 2 plastic Philips screws, give them both half a turn, pop it out and there it is, but where do u find a diagram for the box at?


How do you replace the ignition switch in a 1987 grand marquis with broken tumbles?

found this, might be the same, Merry Christmas, anyways! :) For a 1988 Mercury Marquis remove bottom shroud from steering column (5 Philips head screws). There is a wire running from the ignition switch to the left side of the steering column; detach it from the coupler (This can be done without a tool). Turn key to ON position until the panel lights come on. There is a small pin near the bottom of the key lock; push it in and pull the ignition switch out (don't panic if the wire seems to be stuck; it will come out). To replace, turn new ignition switch to same position. Push pin on the ignition switch in while sliding it back into the steering column. Reconnect wire and then replace shroud.


Where is the flasher turn signals located for a 1988 Mercury Topaz in order to replace or repair one side which is not blinking on turns?

usually this is caused by a burnt out bulb, or one that is about to go


Will a steering column from a 1988 Chevy truck work in a 1988 Chevy suburban?

Yes it will, samething


When was scattergories first played?

It was introduced by Hasbro through Milton Bradley in 1988.