1. Remove the screws from around the outside/underneath of the door trim (5-7 total)
2. Using a very fine pick tool or needle, prise the top of the red/orange tab out from the top approximately 1mm then remove the lock pull upwards. (tab damages easily)
3. Using the pick tool again, prise off the colour coded plastic cover cap in the middle of the interior door handle - remove the 1 screw behind it.
4. Jiggle the plastic door handle free and remove the door handle - remove the screw behind where the handle was, inside the white plastic bracket
---
(with window winders)
5. Push the door trim in where the window winder is, then using a rag in a sawing motion, try to remove the C clip that secures the handle to the shaft. The back of the C-clip is seated forward in the direction of the handle-winder's arm.
(ALTERNATIVE: I use a piece of thin coat hanger wire with small bent-hook end and pull the clip backwards from the shaft).
(with electric windows)
5. easier to remove the trim with the window down. you may want to put the window back up before you undo the electric window plug
---
6. Slowly pry the doorskin from the door, carefully checking for wiring plugs that need to be unplugged or switches to be pushed out then remove the door trim from the door.
Broken off the door or from main body? Main body- Prefabricate. Door- replace door.
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
To install an exterior door handle on a Cherokee Jeep, first remove the window crank handle and the three screws in the inner door trim panel. Second, remove the inner door panel from the door using a trim stick and take off the vapor barrier inside the door. Third, remove the nut on the rear of the door handle, position the exterior door handle, and secure in place.
You will need to remove the inside door panel of your 2002 VW Jetta. Remove the wiring harness from the mirror. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.
check the pull rod from the inside door handle to the door latch. You have to remove the inner door panel. But first, check the switch on the edge of the door to make sure the child safety lock is not engaged. These were designed to prevent kids from opening the door. there should be a little pin switch close to the actual door latch.
The inside door trim is held in place by several retaining clips. Pry outward on each retaining clip to remove the trim.
http://forums.justcommodores.com.au/holden-commodore-how-s/5541-removing-vt-vx-door-trim.html
http://forums.justcommodores.com.au/holden-commodore-how-tos/5541-removing-vt-vx-door-trim.html
Can you get inside the car and remove the interior panel of the door that is stuck ? If you can remove that panel you will be able to manually pull the door catch (And then open the door and have the door latch fixed properly)
passenger side door sill. It is a key switch.
To fix the door handle of a VT Commodore, remove the hardware from the door and loosen the knob. Remove the turn post and tighten all mechanical parts.
Remove the inside door panel and see what has happened. Only then will you know the problem.
hi, open the plastic door under the steering column there should be a diagram inside the door to guide you. There are 4 relays above the fuse panel A,B,C,D the flasher is D.
Broken off the door or from main body? Main body- Prefabricate. Door- replace door.
To remove the door panel on the Holden Astra, first pop off the light lens if the door has a light in the door. Then unhook the light from connector. Remove the screws holding on the armrest, door handle, and window crank if equipped.
To remove the driver's side door panel on a 2001 Holden Astra, first remove the covers for the speakers and any light lenses in the door. Then remove the door panel by inserting a screwdriver in the sides to loosen the clips.
To remove the inside door panel of the Ford F250, first open the door and remove the screws for the door handle. Then, pry the door skin off of the inside starting at the bottom of the door.