answersLogoWhite

0


Best Answer

To remove a starter on a Polaris Sportsman 400 one must either decide first whether they understands well enough to do the task on their own or if a mechanic should be called. Many times people who don't really know what they're doing wind up having left over parts from a vehicle when there should be none other than the replaced part.

User Avatar

Wiki User

βˆ™ 11y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

βˆ™ 10y ago

To remove the front axle from a Kawasaki 2510 mule, refer back to owner's manual. Your owner's manual should have this type of information, if not, contact the dealership.

This answer is:
User Avatar

User Avatar

Wiki User

βˆ™ 11y ago

changing out the starter 2510 mule 4x4

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a starter on a polaris sportsman 400?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

How do you do a boot replacement on the rear axle of a 2001 Polaris Sportsman 400?

remove axle bolt from spindle and push it through you may have to remove spindle if no clearance. remove factory tie strap clean and grease before replacing with new boot reassemble in reverse watch for pin on nut threads reversed on passenger side always consult technical manual and follow safety protocols


Where is the starter located on the Lexus RX300?

where is the starter located on a 95 ls 400 lexus? and what tools a need to change it? underneath the intake, sucks but it can be changed out within a couple hours if you are knowledgeable


How do you change a starter on a 1986 mustang v8?

Hello, If you are talking about the gear on the fly wheel, 1. remove the fly wheel from the back of the motor. 2. Remove any grease and oil. 3. put it into the kitchen oven at 400 deg. for about 20-30 min. 4. Then use pliers to remove or relocate the gear. The gear is made of softer metal than the wheel, so it will exspande at a lower temp and wheel need a higher temp to exspande. The heat from the oven will heat the gear evenly so it can be lifted off with pliers. J.


How much will it cost for a Ford KA starter motor?

It is wise to know the cost of replacing car parts before owning a car. The Ford KA starter motor should cost between $150 and $400.


1976 ford 350 which you have changed the engine from a 400M to a 460 you used a flywheel for a 390 and the bell housing from the 400 you eat starters any help?

a 390 flywheel works for alittle while.but it has 184 teeth ring gear the starter meshes to tight causing starter problems the correct flywheel with cast iron 400 bellhousing is 176 teeth.aluminum hydraulic bell housing 86&up require 180teeth flywheel.make sure you get right fly wheel for internally balanced pre 1979.1980 & up require external balance 24.2 ounce balance.