you set paper on fire and then spit on it
A water balloon is filled with water, and other balloons are filled with air or helium.
easy just put water in th ballon and knot it andyou got a WATERBALOON
There are many chemicals found in a hot air balloon to make it rise. The main elements/chemicals are Helium and Hydrogen.
Balloon twisting is the art of using balloons to make different animals and objects out of balloons. Simple objects can be made from a single balloon and multiple balloons can be twisted to make larger or more intricate designs and objects. A balloonologist is a person that practices balloon twisting, usually as a form of entertainment, rather than just a hobby.
The amount of water that a water balloon can hold before it pops depends on the size and quality of the balloon. Overfilling a water balloon can make it more likely to burst. It is best to follow the manufacturer's guidelines for filling the balloon.
sometimes, depending on how full the water balloon is.
To inflate a water balloon, stretch the balloon opening over a faucet and turn on the water slowly until the balloon reaches the desired size. Alternatively, you can use a water balloon pump to inflate the balloon. Just make sure not to overinflate it to avoid bursting.
To make a balloon hover like a fish in a tank of fresh water, you can fill the balloon with a gas that is less dense than air, such as helium. The buoyant force of the helium will cause the balloon to float in the water similarly to how a fish hovers in a tank.
1 foot
1 foot
6 feet
If you prick a balloon without water, the air inside the balloon will escape rapidly through the hole created by the prick. The balloon will quickly deflate and likely make a popping sound.
You put the end of it on the fauset then turn the water on until the water balloon is as full as you want it to be then you tie it and its ready to go.
you set paper on fire and then spit on it
To use a water balloon launcher, follow these steps: Fill a water balloon with water. Place the water balloon in the pouch of the launcher. Pull back on the launcher and release to launch the water balloon towards the target.
I interpret this question to be asking how one might measure the volume of a water balloon without breaking the balloon or emptying it of the water in order to measure its volume. One method is to fill a container with water that will be large enough to contain the water balloon, and then submerging the water balloon in the container. The volume of the balloon will be the apparent volume change of the water in the container. Any measurement will introduce some error. Since water compresses hardly at all, one would expect that submerging the balloon would not significantly change the volume of the balloon. There could be some error if one had to push down on the balloon to make it fully submerge. There will also be some measurement error in determining the volume change.