0
Lift up the engine cover (under the passenger front seat) by the two hinges and support the engine cover with the clip on the left hand side (should be attached to seat with a bracked on the seatbelt pillar to hook onto).
Battery should be clearly visable. Just connect your postive and negative to the battery (make sure you get it right!) and dont let the wires touch each other and your away!
What else can I help you with?
Where are jump start terminals Mercedes elegance?
The battery post positive terminal is where you connect the positive cable. Connect the negative cable to anyplace on the engine or chassis. Connect positive first and remove it last.
Why won't my 2007 Chrysler pacifica won't start its cold out and the lights was left on all night?
Because you left the lights on all night. This drains the battery. Connect a battery charger and wait about 3 hours. Then the car might start. If it does not start buy a new battery or a new car whichever you prefer.battery juice is gone.
Why when I replaced the starter in my '91 Toyota Camry it sometimes would start sometimes it wouldn't and when it wouldn't you had to wait a few hours before it would start again?
battery needs replacing, make sure you replace it with a battery of correct cranking amps
The car has been left standing for 3 months and will not start no ignition light on the dashboard?
It is very common for the battery to discharge on a vehicle sitting idle for 3 months. First disconnect the positive + & negative- battery cables, and clean the battery post and cable connections off. Apply a thin layer of dielectric grease or Vaseline to the battery post and connect the negative - cable. Put a battery charger on the battery and let it fully charge overnight. If it will not accept a charge it is defective. It it does show fully charged, connect the positive + cable and see if the engine will start. if not, then more than likely the battery is dead and needs replacing.
How long do you have to drive around to charge a car battery after jump starting a car?
You should never drive a car around for long after jump starting a dead battery. This puts an enormous strain on the alternator. Alternators are designed to keep a good battery charged, not to charge a dead battery. You can easily burn out a diode in the alternator. Jump start the engine and drive it somewhere and connect a battery charger to the battery and charge it fully.
2007 Toyota Hiace diesel with fault code P1229 How or where do you start with the repair process of this problem?
P1229
How do you jump start a dead battery on a Toyota Prius?
To jump-start a dead battery on a Toyota Prius, first, ensure both vehicles are turned off. Connect the red jumper cable to the positive terminal of the dead battery and then to the positive terminal of the donor battery. Next, connect the black jumper cable to the negative terminal of the donor battery and attach the other end to a metal ground on the Prius, such as a bolt or bracket away from the battery. Start the donor vehicle, let it run for a few minutes, then attempt to start the Prius.
How do you connect the battery to the coil to start a honda cd175 engine out of the frame and on the bench?
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.
Where to connect negative clamp when charging battery?
Negative battery or jump start post.
How do you change over clutch master cylinder On a Toyota Hiace van 1995 model?
To change the clutch master cylinder on a 1995 Toyota Hiace van, start by disconnecting the battery and ensuring the vehicle is on a level surface. Remove the brake fluid reservoir cap and detach the fluid lines from the master cylinder. Unbolt the master cylinder from the firewall, then replace it with the new unit, ensuring proper alignment. Finally, reattach the fluid lines, refill the brake fluid reservoir, and bleed the clutch system to remove any air.
Toyota Sienna Won't Start?
There could be several reasons why a Toyota Sienna will not start. the most common problem would be a dead battery.
Reason that a 2006 Toyota Highlander will not start?
Dead battery - no gas - ?????
How do you jump start 328i?
You can jumpstart your BMW 328 by connecting jumper cables to your battery and to the battery of another vehicle. Connect the red handles to the positive post, on each battery. Connect the black handles to the negative posts, on each battery. Start the working automobile to charge the nonworking battery.
Your battery died on your 1999 Pontiac transport and you don't know where the negative end to the battery is to jump start it?
Connect positive to positive post (red) on the battery and connect the negative to a place on the engine away from the battery.
Why won't my 2000 Toyota Camry start.?
it probably needs a new battery
How do you demonstrate the correct procedure for jumping to start battery?
Connect positive cable of donor battery to battery of car being jumped. Then connect negative cable to negative battery post on the donor car and lastly to a ground point on the car needing the jump start, normally the engine. Do not connect to negative post of battery needing a jump start. Let donor car run for about 5 minutes and then attempt to start. The instant the engine starts reverse the procedure to disconnect the jumper cables.
Why won't 1993 Toyota Pickup start when it's cold?
It is possible that a 1993 Toyota will not start when it is cold because the battery does not have enough cranking amps to start the vehicle. Check to make sure that the battery is large enough for the job and is also charging properly.
