Is this a commercial Pool?
If yes then what state is the pool located in? Different states, different codes.
Some methods are: based on water volume, surface area, flow rate. Some have a combination of these methods or others.
Please provide the state and I may be able to provide the method used.
yes, California
A: Check with you local department of Health for the most accurate answer. k
Model Code Note - The 2006 ICC International Building Code lists the maximum area allowance per occupant as 50 gross SF per person for the pool itself, and 15 gross SF per person for the deck area.
Similarly, the 2009 NFPA 101 Life Safety Code uses factors of 50 and 30 SF/P. Plus you have to consider the load limits of the approved means of egress from the room (if it's indoors).
how to maintain hardness of wire ,before zinc polish or we can maintain after zinc polish.
while designing a home following point to be consider:- 1) requirement of the occupant. 2)direction(vastu of the plot) 3) budget of the occupant 4)location of the doors .
A jail cell must: * be secure so that it cannot be opened from the inside * be secured in a way that only approved people can open it from the outside * provide shelter for the occupant: dry, warm, and lit * have a means for the occupant to be observed * be difficult to vandalise * not provide means for self harm * have access to toilet facilities
GD2 is defined as a mass moment of inertia with respect to its axis. Some how their is some misconception that GD2 is two different variable, however it is not. Likewise, I=mk2, we have to calculate the mk2 about its central axis.
above ground pool walls have insulation in them
If this pool is indoors consult your local fire marshal for the restrictions on the building occupancy level
By the number of suface area square feet. Check with the local Building Dept. for specs.
not a valid question
If you mean the maximum occupancy of a room, then several things are considered. The square footage of the room, the room's purpose, and the number of emergency exits that exist are factored in.
There are several ways to calculate working load limit. One of these includes Minimum Breaking Load (MBL) divided by Working Load Limit (WLL) equals Working Load Limit (WLL).
no load voltage - full load voltage by full load voltage
Is this a commercial Pool? If yes then what state is the pool located in? Different states, different codes. Some methods are: based on water volume, surface area, flow rate. Some have a combination of these methods or others. Please provide the state and I may be able to provide the method used. yes, California A: Check with you local department of Health for the most accurate answer. k Model Code Note - The 2006 ICC International Building Code lists the maximum area allowance per occupant as 50 gross SF per person for the pool itself, and 15 gross SF per person for the deck area. Similarly, the 2009 NFPA 101 Life Safety Code uses factors of 50 and 30 SF/P. Plus you have to consider the load limits of the approved means of egress from the room (if it's indoors).
lolz
You mean heat load? Use Manual J.
To calculate the DG set current, you need the load current and the load voltage. To convert it into kilowatts it is divided by 1000.
how do i calculate the volumn of backwash in a pool
To calculate the safe working load of a ship's bollard, you need the working stress and the force applied. These two will help you compute the safe working load.