Trunk LH side behind the trunk panel liner. You will find the Rear Electrical module there. Part number on the brake light relay should be 9441161. You will need some sort of wiring diagram as there are a couple of relays used there with that same part number.
wires on the starter are criss crossed
It can be a little expensive to replace the EGR valve on the 1987 Volvo 240 DL. The job takes about 1 to 3 hours and can cost as much as about 240 dollars.
If the wires have been pulled off the 2 x red/black go to pin 15 on the switch. Red goes to 30 (pos. from battery). Blue goes to 50 (starter motor). Yellow to X. White/red to S. and blue/yellow to the un-named contact.
1 3 4 2 with number 1 cylinder being at the radiator end of the engine.
The Chiltons/Haynes 72300 has the vacuum circuits divided into the emissions, Fuel and brakes sections of their manual covering each vacuum hose.
replace ign sw on 1991 volvo 240
The ignition switch on a 1991 Volvo 240 is located on the steering column, just behind the steering wheel. To access it, you may need to remove the plastic cover surrounding the column. The switch itself is typically mounted directly to the ignition lock cylinder. Make sure to disconnect the battery before attempting any repairs or replacements.
wires on the starter are criss crossed
well compare them after you take them out becaue sometimes they have different connections and if they do then you have to switch the plugs to make them fit.
To replace the reverse light switch on a Volvo 240, first, disconnect the battery to ensure safety. Locate the switch, which is typically mounted on the transmission; you may need to remove the air intake duct for better access. Unscrew the old switch, replace it with the new one, and reconnect any wiring. Finally, reconnect the battery and test the reverse lights to ensure they function correctly.
To replace the bulb in the heated seat switch of a Volvo 240 estate, first, carefully remove the switch from the dashboard by gently prying it out. Once removed, disassemble the switch housing to access the bulb, which is typically a small, replaceable type. Remove the old bulb and insert the new one, ensuring it fits securely. Finally, reassemble the switch and reinstall it into the dashboard.
To replace the switch reverse on a 1991 Volvo 240, first, disconnect the battery to ensure safety. Remove the center console cover to access the switch, which is usually located near the gear shift. Disconnect the wiring harness from the old switch, then unscrew and remove it. Install the new switch by reversing these steps, ensuring all connections are secure before reassembling the console and reconnecting the battery.
YES
If they're identical, yes. Try it and find out.
If the indicator lights on a 1993 Volvo 240 remain on when the ignition is off, it may be due to a faulty ignition switch or a short circuit in the wiring. Another possibility is a malfunctioning relay or a stuck switch that fails to turn off the lights. It's advisable to check the vehicle's electrical system for any issues or shorts that could cause this problem. If the issue persists, consulting a professional mechanic would be beneficial.
To replace the rear window defroster switch on a 1983 Volvo 240 GL, first, disconnect the vehicle's battery to ensure safety. Remove the console panel surrounding the switch by unscrewing any screws and carefully prying it off. Disconnect the wiring harness from the old switch, then install the new switch by connecting the harness and securing it back in place. Finally, reattach the console panel and reconnect the battery to test the new switch.
It can be a little expensive to replace the EGR valve on the 1987 Volvo 240 DL. The job takes about 1 to 3 hours and can cost as much as about 240 dollars.