answersLogoWhite

0


Best Answer

windshield wipers have different kinds of speeds such as the ones listed below:

Low speed: Low, Intermediate,High

Normal speed: Low, Intermediate,High (recommended speeds for rain and clean up)

High "" hope i helped

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How are two speed wiper motor run in low or high speed?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why Wipers don't work on high?

Several possibilities are that: 1 the switch is bad on the high position. 2. There is a problem with the high speed wire from the switch to the motor. 3. The wiring inside of the wiper motor for the high speed is bad. The way 2 speed wiper motors work is there are separate windings inside the motor for low and high speeds. Usually 2 wires come out of the motor for low and high and the common ground through the wiper motor body to the chassis of the vehicle. You apply 12v to one wire and get low and 12v to the other one for high speed.


What are the wiper motor wire colors for an S10?

The wire color for a windshield wiper motor in an S10 pickup that connects to the fuse is white. The high speed wire is purple, the low speed wire is gray.


What would cause the windshield wipers to work only on high speed on a Chevy venture?

Bad switch? stalk bad wiper motor? bad low speed winding


What is the maximum current of the pole changing motor when running at low speed and high speed?

The maximum current of the pole changing motor when running at low speed and high speed depends on a few different things. The average when begin at low speed and using high speed is 1800 RPM points.


What would cause the wipers on a 92 grand marquis to only work when set to the highest level and then shut off?

the wiper motor is a basicly a relay switch with low mwdium and high and everything but high is burned out and if it works on high and shuts off you need a new wiper motor.


Why do the wipers on your Pontiac Montana only work on high speed not low or intermittant?

inside the wiper motor there is a diode about 9 millimeters long (22059733). It is probably blown apart. replace with another 6 amp diode. inside the wiper motor there is a diode about 9 millimeters long (22059733). It is probably blown apart. replace with another 6 amp diode.


1999 Chevrolet Suburban winshield wiper works intermitently and only runs on one speed fast What is wrong and how to fix it?

May need new motor low speed winding may be burned out


Which one of the following statements is true of a split phase motor when it is starting the speed is high the torque is high the current is low the voltage is low?

The first statement is true, the motor needs a power source to operate.


How do i fix wipers on 2000 Toyota Camry that only works on low no intermittent or high?

There aren't any switches to check/replace i.e. wiper switch, wiper relay therefore it must be a bad motor.


Is the 1996 Concorde a c fan motor 2speed?

no its 3 on LH body chry the cooling fans are a module and operate together at the same time the speeds are controled by the PCM and are low speed high speed and low/high speed meaning of low/high is both high and low relays are energized at the same time that's how u get 3 speeds


Blower motor works high speed only?

The Blower Motor Relay is shot! You have 2 one for high speed and one for low, they are located under the dash either in the center of the vehicle or off to the right more near the blower motor itself. In some trucks like my 93 Chevy C1500 the high and the low relay are the same part but in other trucks they are 2 different parts. If your stuck on high the low relay needs to be replaced and on stuck on low the high needs replacing. Happy fixing!


2002 gran prix blower fan works on high only?

Low speed (1-4) relay bad Switch bad Low speed motor winding bad