either the ignition coil is bad or the crank for the camfhsaft position sensor is not touching the sensor i jsut had to do that to my car so check both of those
Chat with our AI personalities
If it turns over and will not start you are lacking either spark or fuel. That is about all the information I can give you with the information you have provided.
The cps other wise know as crank position sensor shows the ecm that the engine is turning over and then the ecm turns on the spark and the fuel to allow the car to start. If the cps is bad the ecm won't see the engine turning over so in turn it won't allow fuel our spark.
AnswerIt reads the position and/or speed of an engine as it is rotating. When crankshaft is turning, the sensor will provide a signal to the PCM. The PCM will then allow the engine to start by providing spark and fuel.
there are 2 main reasons 1 the engine is not getting enought petrol 2 spark engine is not getting spark this is probley the cause the main thing that goes wrog with the spark is the ht coil replace this and the spark plug and your engine should start
You need three thing, gas, air and spark for it to start. I would first check to see if you are getting spark. Remove a spark plug and lay it on the engine with the spark plug wire attached and have someone try the starter again. If you see a spark, then that's ok. Got gas? You may be able to spray some starter fluid into the air intake while the engine is turning over to see if it will fire. If it does the problem may be the fuel pump. Good luck
check your accelerator...