0
because it could burn your finger.
Actually , you can get an electric shock at the very least, second degree burns and electric shock are real possibilities.In rare cases, in a person with an undiagnosed cardiac condition, it can cause fibrillation [wild, unregulated beating ] of the heart, and potential cardiac arrest.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What does a three phase motor look like?
A three phase motor looks like any other motor from the outside. It might be a little larger than a standard motor but it looks the same. If it is not hardwired but has a plug, the plug will have four prongs instead of three. The socket will look different from a standard socket or the socket for a stove or air conditioner. It will also have four holes. The hole for the ground plug will have a special indent. That makes it so you can not put the plug in wrong. A two phase motor will run the correct way regardless of how you put the plug in the socket. If you would put the plug for three phase motor in the socket the wrong way, the motor would run backwards.
Is it dangerous to put plugs in wall sockets when they are switched-on English sockets?
This question may be asking if it is safe to plug things into mains wall sockets if they have been left switched on with nothing plugged-in, and if it is safer to plug things in only after the sockets have been switched off? If, and only if, that is the meaning of this question, the answer is probably: It should not be dangerous to plug something into a switched-on socket but it is always a good idea - and safer - to switch off any socket before you plug anything into it. +++ The hazard is not in the plugging-in, but may arise from the appliance itself, if it starts unexpectedly.
What do you measure in fingers?
If you are a male put both index fingers next to eachother than that symbolises how long your penis is. (when i say put both index fingers together i mean nail to nail, if that makes sense)
Can i put a 120V led bulb in a 12V socket?
yes
How do you change the spark plugs on a 2002 Volvo S40?
to change the plugs you must take off the spark plug boots..you then take the spark plugs out with a 5/8 sparkplug socket..put the new plugs in the holes and finger tighten them a little(with the socket and extension so that it doesnt cross thread)it might also be wise to replace the wires if they look bad or cracked..
Can all things be Electrified?
yes if you have wet fingers and put two of you fingers in a plug socket you'll most probally die so most warning signs are there to keep you safe :)
Why should never place a metal in a plug socket?
it is a fatal risk of getting electrocuted if you insert any metal piece into a plug socket. Hence do not put any metal in to plug socket
How do you install spark plugs on a Chevy suburban v8 c1500 1996?
Take your fingers and twist the plug wire left and right a few times then pull it off the plug. Take a 5/8 inch socket and put it on the plug and turn it to the left and screew it out of the head. THATS IT.
You broke a plug trying to remove it what is the best way to get it out?
Usually if you break a plug it is only the top white ceramic part. The only time this would be a problem is if your plugs are in the top of the head and down in a hole. They do make needle nose pliers long enough to reach down and get the plug. The ceramic part should have come out with the socket if using a regular spark plug socket. That would leave just the base. Take the socket and put a piece of tape on the inside of the socket on each face. Bring it out over the edge of the socket and onto the outside. This will make the socket enough smaller that it should hold on to the base of the spark plug so you can get it out.
What are the release dates for The Kids from Room 402 - 1999 Don't Put Your Fingers in the Light Socket 2-21?
The Kids from Room 402 - 1999 Don't Put Your Fingers in the Light Socket 2-21 was released on: USA: 2000
When does electricity become dangerous to people?
when you put your penis in a plug socket for pleasure
Can you convert a garage light socket to accept a three prong shop light plug in?
If you want to you could remove the light socket and put in an outlet then plug your light into the outlet.
Where is the spark plug on a John Deere LT133?
Look at the oil fill. The place where the dip-stick is. You will see a metal clamp. Follow that clamp to the front. There you will see a black wire. That is the wire that goes to the spark plug. Gently pull the wire off and then you will see the spark plug. You will need the the long 1/2" socket in order to fit into the space to loosen the plug. When you put the new plug in,use the socket to help you. It will be easier for you. Your fingers will not fit. Good luck, Lou
How do you change spark plug on snapper sx5200 snapper snow blower?
Take off the gas cap. Take off the big plastic cover with a socket and wrench.Then put the gas cap back on. Then pull of the spark plug boot. Then take off the spark plug with a spark plug socket and wrench. It should be 13/16" socket with 3/8" drive wrench. I Think the spark plug gap is 0.025 but you would have to look at a manual.
What does a three phase motor look like?
A three phase motor looks like any other motor from the outside. It might be a little larger than a standard motor but it looks the same. If it is not hardwired but has a plug, the plug will have four prongs instead of three. The socket will look different from a standard socket or the socket for a stove or air conditioner. It will also have four holes. The hole for the ground plug will have a special indent. That makes it so you can not put the plug in wrong. A two phase motor will run the correct way regardless of how you put the plug in the socket. If you would put the plug for three phase motor in the socket the wrong way, the motor would run backwards.
Where do you plug in a headset with only 1 plug?
When in doubt, put it in the green socket. It might also be marked as "speaker" or "headphones." You can try the headset plug in front if there is one there. Otherwise, try the green or "speaker" socket in the back if there is one there.
Change spark plugs 88 V8 camaro?
pull off one wire at a time and take a socket wrench the right size socket and turn them out counter clockwise installation is the opposite way do that for every plug pull off one wire at a time and take a socket wrench the right size socket and turn them out counter clockwise installation is the opposite way do that for every plug pull one plug off at a time use a socket wrench to get the plug out turn counter clockwise to remove install the new plug put the wire back on do that for each plug
