Your valve timing is off
The o2 sensor is not reading properly causing the system to go very lean.
They typically screw into the exhaust manifold and have an electrical connection. They're easy to remove/replace, but sometimes getting to them can be a little difficult.
Newer oxygen sensors are heated for accuracy. If the heater element goes bad the oxygen sensor doesn't work and needs to be replaced. If you have an oxygen sensor heater malfunction, it just means that the oxygen sensor has failed.
oxygen sensor
analog sensor
A sensor that measures flow and pressure of the fluid in a hydraulic system.
The oxygen sensor is located in the exhaust manifold before the catalytic convertor. If you look down between the radiator and the exhaust manifold a few inches before the exhaust pipe connects to the exhaust manifold you will see the Oxygen sensor. The sensor will have 2 wires coming from it and it kinda looks like a sparkplug stuck into the exhaust manifold. There is 2 nuts that hold the oxygen sensor into the exhaust manifold.
By "exhaust manifold sensor" do you mean the O2 or oxygen sensor? The only sensor I know of on a exaust manifold is the O2 sensor and if you follow the manifold you will see 2 sensors sticking out they will have (usually) green wires coming from them
Screwed into the exhaust manifold.Screwed into the exhaust manifold.
In the exhaust manifold behind the engine.In the exhaust manifold behind the engine.
In the exhaust manifold on the back of the engine.In the exhaust manifold on the back of the engine.
02 sensor is either in exhaust manifold, or in exhaust pipe between manifold and muffler
exhaust manifold
your oxygen sensor should be located on your exhaust manifold or on the exhaust pipe near the exhaust manifold, Make sure your engine is cool before placing your hands on the exhaust manifold, It can be very hot!
oxygen sensor is found either in exhaust manifold or in actual exhaust pipe between manifold and muffler
Bank 1 oxygen sensor is the closest to the engine exhaust manifold. It is usually can seen and replaced if necessary with open hood.
it is in the exhaust manifold,or exhaust pipe...
The oxigen sensor can be found on the exhaust manifold or exhaust pipe