0
Why is my car fine driving in first and2nd but losses power in 3rd gear?
Wiki User
∙ 13y ago
Because as you go into higher gears power tends to decrease. Depending on how many gears you have it will either happen sooner or later. 1st and 2nd are always your most powerful gears though.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Explain the power flow diagram of induction motor?
The input power, Pin, is reduced by different loss sources in the system. These reductions are the difference between input power & output power. The losses are: PSCL: Stator copper losses, or I2R losses Pcore: Core losses PRCL: Rotor copper losses PF&W: Friction & windage losses Pmisc: miscellaneous losses All of these losses reduce the input power. The output power is the input power minus all of the losses. Pout = Pin - PSCL - Pcore - PRCL - PF&W - Pmisc
What are the three main power losses that contribute to transistors junction temperature?
Switching losses Conduction losses
What is the significant relationship of the no load loss in excitation current test in transformer?
The no load losses are the losses caused by energizing the transformer. These are constant losses, regardless of loading. This in effect tells you the efficiency of the transformer. (Power in) - (no load losses) = (Power out)
What is the E-AT switch for in your Nissan pickup?
first, go to a junk yard and look for an owner's manual. the E-AT switch is for your driving pattern. the E-AT is every day driving. power is for when you think you need more power, such as a tow.
My car losses power when im driving what's wrong with it?
Worst case scenario Timing belt has slipped Transmission needs service(a proffessional tranny shop can get the codes from transmission) fuel pump
What is the effective radiated power formula?
EIRP (Dbm)= Output Power(Dbm)-Losses(from cables & adapters)+Antenna Gain(Db)
What does it mean to dissolve the constitution?
Dissolving the constitution means when the government in power losses its power.
How do you calculate copper losses?
copper losses are power losses due to flow of current in the wires or resistances,if the resistance is R, current is I then copper losses are I2R. for a 3-phase system; copper losses are same but for a single line, total losses are 3I2R.
What is the formula for counting the energy that can be made by a dynamo?
i think it goes from kinetic to electric + sound
Can digital power meter read the power losses?
Yes. It depends how you want to use the meter
Factor affecting of PTO power that can be transformed into drawbar power?
First, I do not understand exactly what answer the question is trying to get at. PTO power is rotational power and is based upon the power developed by the source engine, the method of transmitting this engine power to the PTO and other losses such as lubricants. Draw bar power is the ability to pull (usually horizontally) and is based upon the power developed by the source engine, the method of transmitting this engine power to the wheels/tracks/etc and other losses such as lubricants. Draw bar power also must consider losses from slippage from the wheels/tracks/etc including the surface you are working on (asphalt road, plowed field etc). Perhaps the question could be better answered if it were further refined/defined or improved.
Your car lost power while driving and now will not start?
my car has no power when driving. plus its hard to start. after i ran it low on fuel
