0
The clutch pedal dropping to the floor indicates no pressure to hold it up. In a hydraulic system the master cylinder or slave cylinder have either gone bad or the fluid is too low. If fluid is low then air has gotten into the lines preventing the pressure from operating the clutch. This can also be caused by a broken arm attached to the pedal.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Why wont your clutch work?
my clutch went to the floor what happened?
Why does your clutch pedal touch the floor?
It's called: Your clutch is working.
2005 Sunfire clutch is stuck to the floor?
Well, we need lots more information here. Is the clutch pedal actually "stuck" to the floor? In other words, can you NOT lift the pedal up to the normal position? OR, has the clutch pedal "fallen" to the floor due to no resistance from the clutch?
Why does my clutch pedal go straight to the floor and stays down with no pressure?
You have a broken clutch.
Rover mg zt clutch pedal gone to the floor?
The clutch cable has proabably broken.
My clutch pedals goes to floor and can't shift gears is my clutch bad?
Sounds more like a clutch slave cylinder.
Where does the clutch fluid go in a suzuki intruder?
On The Floor.
Clutch is sticking to the floor and has no pressure Toyota Camry?
Clutch fork or cable broken. it might have a hydrolic leak. Check the master in the clutch
Would the clutch pedal going to the floor and staying on the floor be just the clutch going out or what could it be if so and how do you replace the clutch on a 2001 Maxima?
You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.
How do you adjust the clutch on a 2008 Chrysler pt cruiser?
depress the clutch pedal to the floor several times
2001jeep wrangler 5 speed no problem w clutch before shifted to 2nd clutch fell to floor now hard to push to the floor when running push in clutch it shutters and metalic zzz new clutch or slave cylin?
Sounds like the throw-out bearing
Why does the clutch pedal stick to the floor?
You've blown a clutch hose by the sound of it, or you've got a leak in the clutch master or slave cylinder. Either way, without clutch fluid, the clutch pedal wont come off the floor and the clutch will be disengaged. Any half decent mechanic should be able to figure out what the issue is without charging and arm and a leg.
