The engine also jumps when changing to Neutral and Drive. Should I have Transmission Fluid change? A/C was not on.
Take it out of reverse.
Shift linkage out of adjustment?
What kind of noise? It could just be the park lock solenoid clicking when it releases to engage drive, this wouldn't come from the gearbox though, it would be from the gear selector unit under the centre console.
are you pressing the brake as you try to shift?
neutral safety switch/ or reverse switch faulty thanks. how would i go about replacing the safety switch? is it difficult?
I have a 1992 Chevy berretta 3.1 V6 and when it is in park and reverse and neutral it sounds like there is a grinding noise right below the shifter I know that the linkage needs adjusting any ideas
Reverse Cowgirl - South Park - was created on 2012-03-14.
yes
It might be a problem with your transmission because not all mx6's stall when you put it in drive or reverse.
Remove the rear speaker covers from your 2000 Buick Park Ave. Remove the rear speaker retaining screws. Remove the wiring harness. Reverse the process to install the new rear speakers.
I would bet that it is a wheel bearing, i was experiencing the same thing. i didnt notice it at driving speed because of engine noise.
A car might stall when shifting from park to reverse if the idle is set too low. It is also possible that the engine stalls because it is not fully warmed up before shifting from park to reverse.