0
It just helps to mix the two solutions better adn quicker. If you don't swirl your results are going to be a little off.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
During titration why use a conical flask and not a beaker?
So you can swirl the contents around without spilling them. =]
Why the titration flask need to be shake during titration?
so that the solutions mix properly
What is the endpoint of a titration?
during a titration when a titrant completely furnished the sample then this is the end point of titration.
What is a potentiometric titration?
A potentiometric titration is one in which the end-point is detected by measuring the change in potential of a suitable electrode during the titration.
Difference between precipitation titration and complexometric titration?
During a precipitation titration an insoluble precipitate is formed.Complexometric titration is a type of volumetry which use as titrants EDTA or other similar reagents.
During titration why use a conical flask and not a beaker?
So you can swirl the contents around without spilling them. =]
Why the titration flask need to be shake during titration?
so that the solutions mix properly
What is the endpoint of a titration?
during a titration when a titrant completely furnished the sample then this is the end point of titration.
What is the reason of heating solution during redox titration?
This is far to be a rule for this titration.
What is a potentiometric titration?
A potentiometric titration is one in which the end-point is detected by measuring the change in potential of a suitable electrode during the titration.
Difference between precipitation titration and complexometric titration?
During a precipitation titration an insoluble precipitate is formed.Complexometric titration is a type of volumetry which use as titrants EDTA or other similar reagents.
Why is it important to swirl the flask when you are performing a titration?
It is just to thoroughly mix the reagents, in order to not have any un-reacted starting reagents. If you do not mix them thoroughly you cannot effectively tell when the titration is complete. The same effect can be attained using a stir bar with stir plate.
What is the purpose for using phenolphthalein for an acid base titration?
It's the colour indicator you watch for during the titration.
What happened if some solution splashes out during the titration of NaOH?
If some solution splashes out during the titration of NaOH, the volume at the end point will be wrong.
Need of blank titration?
to reduce error
What is the purpose of adding dextrin in titration?
In a precipitate titration, dextrin is added to prevent the precipitate from coagulating during titration. It also makes the color change more visible, since some analytes may be difficult to see a color change during the titration. I hope this helps! This is straight out of my Analytical Lab manual.
What is the need for an ammonical buffer solution in the determination of hardness of water by edta titration?
during the complexometric titration using edta it is very necessary to maintain the ph of the solution near about 10 so we use ammonium chloride buffer if we will not use this buffer dring the titration ph of sol. will ho lower side
