The arrows point to the front of the engine.
1967, 2 bolt main bearing, small crank wrong way
Absolutely. The ONLY parts that aren't interchangeable between a 2 bolt and 4 bolt block are the main bearing caps themselves. The crank, rods, pistons, camshaft, oil pump, etc, are ALL interchangeable. So yes, the pistons will work just fine.
Main bearing torque on 98 Chevy 350 4 bolt main?? The main bearing caps should be torqued to 70 ft. lbs.
70 ft lbs
Should be one 10mm bolt.
Under the car in the back of the motor.8mm bolt holds it in
the is a bolt right behind the transmisson that you turn
the crank sensor is located on the back of the engine aprox. 1 inch above the oil pan. there is one bolt holding it in place, after removing the bolt pull the sensor out installation is reverse
There are bolt all over the crank and they have different torque values. Here are a few. Crankshaft main bearing cap bolt - 36.5 - 41 .O in. lbs. Crankshaft pulley bolt - 7.5 - 9.0 in. lbs. Crankshaft timing belt pulley bolt - 47.5- 5 4 . 0 in. lbs.
Use an impact gun or secure flywheel when loosening crank bolt.