0
What else can I help you with?
Where does the vacuum advance hose hook up to a holley 650?
Any place that has constant vacuum Usually on the back side at the base of the carb.
Vacuum advance hook up on 63 Chevy 283 engine?
There should be a vacuum source on the carb above the throttle body that gives spark ported vacuum. You can connect a tube from this source to the distributor.
Which vacuum port on a eldabrock carb do i hook to the vacuum on the dist the one that has 18 inches of vacuum at idle or the one that is 0 inches at idle but comes up with acceleration?
Your distributor needs vacuum to advance your timing during acceleration. That's why you hook up your line to the port that has no vacuum at idle. :O)
You recently installed a 600cfm edelbrock carb on your 75 Nova you were wondering where do you hookup the distributor to the carb?
There should be two small and one large vacuum connection points on the front of the carb, hook it to one of the small ones, that will be for your vacuum advance. the big one is for crankcase ventilation. one of the smaller ports is manifold vacuum, the other is timed vacuum. they are not the same, but you will use one of these, usually the "timed" port.
79 Yamaha xs 1100 vacuum lines?
vacuum lines,there are three one for each petcock and one for the vacuum advance, the two for the petcocks go to the carb boots, one on each side,and the one for the vacuum advance goes directly to the no. two carb.
Carb backfires when given more gas?
Check your timing and your vacuum advance.
Where should the vacuum advance be connected to on a 350 Chevy with a 2 barrel carb?
Look on the carb for a small vacuum source above the throttle body. You would want one that has no vacuum at idle.
What does the PCV valve hook up to?
It hooks up to the vacuum ports on the carb or intake.
How do you hook up the vacuum hoses on a distributor to carburetor?
If it is a point type distributor you will want to hook it to constant vacuum...somewhere on a port in the base plate. If it's HEI you'll want to hook it to one in the carb body. Something that has no vacuum at idle but pulls vacuum as you give it throttle.
Where does the vacuum advance on the distributor go does it go to the carb or somewhere else?
It depends on the year of the car.....but if you are running HEI ignition (74 and later) it will run to the carb. It goes to a ported vacuum signal. You will find a ported vacuum on a fitting that is above the carb base plate. It should have no vacuum when the engine is idling but will have vacuum when you rev the engine.
Where should the vacuum advance be connected to on a Chevy 350 with a holley 650 carb?
It has to be hooked to a vacuum port that only has vacuum on it when you give it gas, That is called ported vacuum. If you look at the holly, you will see some small vacuum ports on it, start engine and witch ever one don't suck on your finger then that will be the 1 you hook it to. Then plug the rest if you don't need them for something else.
Where does distubtor vacuum hook up on 350 2 barrel?
Connect the line to a source that is above the throttle body on the carb. It should be a source that has no vacuum at idle.
