500
If your talking about vacuum 500 microns of Hg is lower.
21.1" vacuum
The first known method of artificial refrigeration was demonstrated by William Cullen at the University of Glasgow in Scotland in 1748. Cullen used a pump to create a partial vacuum over a container of diethyl ether, which then boiled , absorbing heat from the surrounding air. The experiment even created a small amount of ice, but had no practical application at that time. ~From Wikipedia- Refrigeration
You should not put chemicals in the pool while the vacuum is in. Put the chemicals in and give them a chance to work first. Then you can vacuum and backwash the filter as needed.
No, There should be a media.
30in is 762000 microns of vacuum
If your talking about vacuum 500 microns of Hg is lower.
vacuum is measured in pressure. To get a vacuum you need a negative pressure. that would be inches of mercury hg
I don't see how the sucking capacity of a vacuum would be measured in units of length.
yes
that theres a vacuum on it
A vacuum
I fix Coke coolers and vendors usually r134a and r 12 134a is 20 pressure and 12 14 to 16 alot easier to add with scale after pulling a vacuum
Use a vacuum pump that pulls it into a tank.
The particles are too fine for the sand to trap, sand filters trap particles down to 25 microns. Dead algae can be a lot finer than that. The only filter that can trap real fine particles down to 3 microns are d.e. filters.
yes
One can apply vacuum at any point in a refrigeration loop to evacuate air and moisture. The compressor is not running during this time and so it doesn't matter.