0
Your ac contractor or engineer will determine the correct size.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you calculate the return air grillsize in an air conditioning system?
really depends on the size of the unit but if your not sure i would go with a 20x20 or a 20x25 filterback grill..
How big should an air return be how many square inches per square foot of house?
Air return duct and filter grille size is dictated by the size of the unit (CFM) not the size of the house.
What size should the return air filter grill be on a 2 ton unit?
The best rule of thumb I have found is: Length X Width / 144 * 288 = Max. CFM I have used this formula to size many HVAC systems. It has always worked. For example, a 5 ton unit should have a 30x36 grille(2-18X30 filters). (30x36)/144*288=2160 max cfm. Return Air should be sized at 200 square inches per ton according to AirMate and other filter grille manufacturers to achieve 2.0 static pressure. The Return Air Duct should have an unobstructed 6 square inches per 1000 BTU of cooling.
What size unit should a 2650 square foot house have?
a 4 ton unit
What size duct for cold air return for 3 ton unit?
A 16" round flex duct will accommodate up to a 3.5 ton unit
How do you calculate the louver vent size for return air required for an exhaust fan?
quick down and dirty way is the size of your unit (example..4 tons) X 144= the square inches needed for the return vent size or the longer way Max air flow from unit (rated size) / 2.08 cfm/sq in= filter area needed
How do you remove the grill assembly from a 1999 Ford Expedition?
The grill if I recall correctly is one unit. What I mean by one unit is that the grill housing goes around the headlights / around the whole front of the vehicle. I have a 1998 Ford Expedition XLT. I ended up cutting my grill out of the housing and installing an aftermarket one in its place.
What is the size of a metric unit?
The size of any unit is, by definition, 1.
What size breaker should you use for a unit that draws 58 running amps?
70 amp
How Cold Should the Air Be from your Air Conditioner?
There should be appx 15*-20* difference between return and supply air temps measured at the unit (not the registers).
What are some characteristics of unit rates?
it should be well defined it should be of suitable size it should be internationally accepted it should be easily reproducable it should not be affected by the environmental conditions
How do you calculate the watts of a central air and heat unit?
You should not have to calculate the watts of the unit. All the information that you need will be on the nameplate of the unit. It is this information that electricians use to calculate the conductor size and breaker to supply the power to the unit.
