1meter
Your question is unclear. But, if you are asking what the relationship between voltage and the distance between conductors is, then the higher the voltage, the greater the distance must be.
It's a diagram showing the components and connections needed to build a voltage stabilizer. The diagram will show a power transistor and a voltage reference, such as a zener diode.
in servo stabilizer voltage deviation is less(nearly+-1),in stabilizer it is +-10.The reason is in stabilizer there is only 3 or 4 out put based on input,but servo stabilizer works with servo motor therefor it will vary the out put with input through its movement over the transformer coils ,out put is taking from the contact portion of the servo motor with the generator coil.in stabilizer out put is taking from some intervals .
Yes.
The website Ehow has detailed instructions on how to install a voltage stabilizer. It is installed into an existing circuit to protect a component from receiving more voltage than it can handle.
30 cm
Voltage stabilizer is use to regulate the voltage the output of any device
Voltage Stabilizer is also called Automatic Voltage Stabilizer or AC Voltage Stabilizer or Voltage Regulator. Actually an automatic voltage stabilizer is designed to automatically maintain a constant voltage level, with protections of equipment against voltage surges, over voltage, under voltage, smoothing impulsive noise.
the minimum distance between two cable joint 2 meter (refer IEC 60052-4)
voltage stabilizer advantages and disadvantages
A voltage regulator is a circuit or device designed to deliver a constant voltage at its output regardless of changes in load current.A voltage stabilizer is a circuit or device designed to deliver a constant voltage at its output regardless of changes in incoming voltage.
is there a minimum distance between 480 volt phases. ANOTHER ANSWERThere is no such thing as a 'phase-to-phase' voltage. The correct term is 'line-to-line', which is why that voltage is called a 'line voltage'. The distance between these line conductors depends on the value of the line voltage; the greater the line voltage, the greater this distance must be to prevent any flashover. These distances are specified in the utility company's standards or regulations.
The minimum electrical clearance is the minimum distance between electrical conductors with different potentials (voltage). This generaly determined by the maximum possible voltage differenge between the conductors. Dimensions larger then the minimum electrical clearance are OK, however smaller dimensions start to risk arc-over between your conductors.
Your question is unclear. But, if you are asking what the relationship between voltage and the distance between conductors is, then the higher the voltage, the greater the distance must be.
A CVT (Constant Voltage Transformer) is always better than a Servo Stabilizer. But a CVT is costlier than a Servo Stabilizer of same rating.
It's a diagram showing the components and connections needed to build a voltage stabilizer. The diagram will show a power transistor and a voltage reference, such as a zener diode.
The distance between high voltage lines is governed by either a switching impulse voltage or lightning impulse voltage. The distance between lines, or lines and tower must have a high enough dielectric strength to avoid flashover at these voltage. Air can withstand a voltage of 3kv/mm.